Paula N. Brown

Paula N. Brown

Auto-generated profile, based on publicly available information

Paula N. Brown

Natural Health and Food Products Research Group, Centre for Applied Research and Innovation, BC Institute of Technology

Research Focus & Metrics

Academic Career Length

20Years (2007-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 March 2011 in Journal of AOAC INTERNATIONAL
Verified
Journal Article
Open access
PDF file
PBPaula N Brown
Paula N Brown
PSPaul R Shipley
Paul R Shipley
A single-laboratory validation study was conducted on an HPLC method for the detection and quantification of cyanidin-3-O-galactoside (C3Ga), cyanidin-3-O-glucoside (C3Gl), cyanidin-3-O-arabinoside (C3Ar), peonidin-3-O-galactoside (P3Ga), and peonidin-3-O-arabinoside (P3Ar) in cranberry fruit (Vaccinium macrocarpon Aiton) raw material and finished products. An extraction procedure using a combination of sonication and shaking with acidified methanol was optimized for all five anthocyanins in freeze-dried cranberry fruit and finished products (commercial extract powder, juice, and juice cocktail). Final extract solutions were analyzed by HPLC using a C18 RP column. Calibration curves for all anthocyanin concentrations had correlation coefficients (r2) of 99.8. The method detection limits for C3Ga, C3Gl, C3Ar, P3Ga, and P3Ar were estimated to be 0.018, 0.016, 0.006, 0.013, and 0.011 g/mL, respectively. Separation was achieved with a chromatographic run time of 35 min using a binary mobile phase with gradient elution. Quantitative determination performed in triplicate on four test materials on each of 3 days (n 12) resulted in RSDr from 1.77 to 3.31. Analytical range, as defined by the calibration curves, was 0.5736.53 0000000g/mL for C3Ga, 0.159.83 g/mL for C3Gl, 0.2817.67 g/mL for C3Ar, 1.0164.71 g/mL for P3Ga, and 0.4227.14 g/mL for P3Ar. For solid materials prepared by the described method, this translates to 0.063.65 mg/g for C3Ga, 0.020.98 mg/g for C3Gl, 0.031.77 mg/g for C3Ar, 0.106.47 mg/g for P3Ga, and 0.042.71 mg/g for P3Ar.

23 February 2017 in Analytical and Bioanalytical Chemistry
Verified
Journal Article
Open access
PDF file
EMElizabeth M. Mudge
Elizabeth M. Mudge
SMSusan J. Murch
Susan J. Murch
PBPaula N. Brown
Paula N. Brown
There is an explosion in the number of labs analyzing cannabinoids in marijuana (Cannabis sativa L., Cannabaceae) but existing methods are inefficient, require expert analysts, and use large volumes of potentially environmentally damaging solvents. The objective of this work was to develop and validate an accurate method for analyzing cannabinoids in cannabis raw materials and finished products that is more efficient and uses fewer toxic solvents. An HPLC-DAD method was developed for eight cannabinoids in cannabis flowers and oils using a statistically guided optimization plan based on the principles of green chemistry. A single-laboratory validation determined the linearity, selectivity, accuracy, repeatability, intermediate precision, limit of detection, and limit of quantitation of the method. Amounts of individual cannabinoids above the limit of quantitation in the flowers ranged from 0.02 to 14.9% w/w, with repeatability ranging from 0.78 to 10.08% relative standard deviation. The intermediate precision determined using HorRat ratios ranged from 0.3 to 2.0. The LOQs for individual cannabinoids in flowers ranged from 0.02 to 0.17% w/w. This is a significant improvement over previous methods and is suitable for a wide range of applications including regulatory compliance, clinical studies, direct patient medical services, and commercial suppliers.

30 August 2018 in Scientific Reports
Verified
Journal Article
Open access
PDF file
EME. M. Mudge
E. M. Mudge
Susan J. MurchSusan J. Murch
Susan J. Murch
PBP. N. Brown
P. N. Brown
Cannabis is an interesting domesticated crop with a long history of cultivation and use. Strains have been selected through informal breeding programs with undisclosed parentage and criteria. The term “strain” refers to minor morphological differences and grower branding rather than distinct cultivated varieties. We hypothesized that strains sold by different licensed producers are chemotaxonomically indistinguishable and that the commercial practice of identifying strains by the ratio of total THC and CBD is insufficient to account for the reported human health outcomes. We used targeted metabolomics to analyze 11 known cannabinoids and an untargeted metabolomics approach to identify 21 unknown cannabinoids. Five clusters of chemotaxonomically indistinguishable strains were identified from the 33 commercial products. Only 3 of the clusters produce CBDA in significant quantities while the other 2 clusters redirect metabolic resources toward the THCA production pathways. Six unknown metabolites were unique to CBD-rich strains and/or correlated to CBDA and 3 unknowns were found only in THC-rich strains. Together, these data indicate the domestication of the cannabis germplasm has resulted in a loss of the CBDA pathway in some strains and reallocation of resources between CBDA and THCA pathways in others. The impact of domestication is a lack of chemical diversity and loss of biodiversity in modern cannabis strains.

9 March 2015 in Journal of Natural Products
Verified
Journal Article
Open access
CTChristina E. Turi
Christina E. Turi
JFJamie Finley
Jamie Finley
PSPaul Shipley
Paul Shipley
SMSusan J. Murch
Susan J. Murch
PBPaula N. Brown
Paula N. Brown
Metabolomics is the qualitative and quantitative analysis of all of the small molecules in a biological sample at a specific time and influence. Technologies for metabolomics analysis have developed rapidly as new analytical tools for chemical separations, mass spectrometry, and NMR spectroscopy have emerged. Plants have one of the largest metabolomes, and it is estimated that the average plant leaf can contain upward of 30 000 phytochemicals. In the past decade, over 1200 papers on plant metabolomics have been published. A standard metabolomics data set contains vast amounts of information and can either investigate or generate hypotheses. The key factors in using plant metabolomics data most effectively are the experimental design, authentic standard availability, extract standardization, and statistical analysis. Using cranberry (Vaccinium macrocarpon) as a model system, this review will discuss and demonstrate strategies and tools for analysis and interpretation of metabolomics data sets including eliminating false discoveries and determining significance, metabolite clustering, and logical algorithms for discovery of new metabolites and pathways. Together these metabolomics tools represent an entirely new pipeline for phytochemical discovery.

1 April 2016 in Journal of Food Composition and Analysis
Verified
Journal Article
Open access
EMElizabeth Mudge
Elizabeth Mudge
WAWendy L. Applequist
Wendy L. Applequist
JFJamie Finley
Jamie Finley
PLPatience Lister
Patience Lister
ATAndrew K. Townesmith
Andrew K. Townesmith
PBPaula N. Brown
Paula N. Brown
American elderberries are commonly collected from wild plants for use as food and medicinal products. The degree of phytochemical variation amongst wild populations has not been established and might affect the overall quality of elderberry dietary supplements. The three major flavonols identified in elderberries are rutin, quercetin and isoquercetin. Variation in the flavonols and chlorogenic acid was determined for 107 collections of elderberries from throughout the eastern United States using an optimized high performance liquid chromatography with ultraviolet detection method. The mean content was 71.9 mg per 100g fresh weight with variation ranging from 7.0 to 209.7 mg per 100 g fresh weight within the collected population. Elderberries collected from southeastern regions had significantly higher contents in comparison with those in more northern regions. The variability of the individual flavonol and chlorogenic acid profiles of the berries was complex and likely influenced by multiple factors. Several outliers were identified based on unique phytochemical profiles in comparison with average populations. This is the first study to determine the inherent variability of American elderberries from wild collections and can be used to identify potential new cultivars that may produce fruits of unique or high-quality phytochemical content for the food and dietary supplement industries.

29 September 2015 in Food Analytical Methods
Verified
Journal Article
Open access
PDF file
EMElizabeth Mudge
Elizabeth Mudge
MCMichael Chan
Michael Chan
SVSylesh Venkataraman
Sylesh Venkataraman
PBPaula N. Brown
Paula N. Brown
Curcuma longa L. rhizomes are used extensively as a spice in food preparations and dietary supplements for their anti-inflammatory and antioxidant properties. An expert review panel (ERP) evaluated analytical methods for the quantitation of individual curcuminoids for the purpose of identifying a method for official method status. It was requested that several modifications be undertaken to improve method performance prior to subjecting the chosen method to a single-laboratory validation. Two separate Plackett-Burman factorial studies were used to identify factors that contributed to the chromatographic separation and extraction of curcuminoids. Significant factors were further optimized to produce the improved HPLC method for curcuminoid separation. This method was then subjected to a single-laboratory validation according to the AOAC International guidelines for linearity, detection limits, precision, and accuracy. The two most significant factors impacting the quantitation of curcuminoids were column temperature and extraction solvent, which were optimized to 55 °C and 100 % methanol, respectively. The validation was performed on 12 raw materials and finished products containing turmeric roots. The method precision was reported using HorRat values which were within recommended ranges of the AOAC guidelines. Overall accuracy of the method was accessed at three separate levels for each analyte and ranged from 99.3–100.9 %. The validated method is suitable for quantitation of individual curcuminoids in turmeric raw materials and finished products and is recommended for consideration as an official method by the AOAC International.