WO3 nanorods targeted for applications in electric devices were grown from a tungsten wire heated in an oxygen atmosphere inside an environmental transmission electron microscope, which allowed the growth process to be observed to reveal the growth mechanism of the WO3 nanorods. The initial growth of the nanorods did not consist of tungsten oxide but rather crystal tungsten. The formed crystal tungsten nanorods were then oxidized, resulting in the formation of the tungsten oxide nanorods. Furthermore, it is expected that the nanorods grew through cracks in the natural surface oxide layer on the tungsten wire.
Electron energy loss near-edge structures (ELNES) and first-principles band structure calculations were combined in order to identify native defects which are segregated by heat treatments at the vicinity of SrTiO3 grain boundary (GB). Spectral differences between the bulk and the vicinity of GB mainly appear around the second peak of OK ELNES. The spectral differences can be reproduced by calculating the theoretical OK ELNES from the first-nearest-neighbor oxygen to a Sr vacancy. It is therefore concluded that the Sr vacancies are concentrated in the vicinity of GB by the heat treatment.
The defect structure of a homoepitaxial thin film of SrTiO3 containing excess Ti grown by pulsed laser deposition is investigated. The Sr/Ti ratio of the film is controlled to possess a slight excess of Ti by tuning the laser fluence. High-resolution transmission electron microscopy and electron energy loss spectroscopy studies reveal that the film contains Sr vacancies because of the presence of excess Ti. These vacancies tend to cluster as platelets several nanometers in diameter on (001) planes in the films. The SrO planes that contain the vacancy clusters exhibit lattice expansion due to Coulomb repulsion.
Ruddlesden-Popper (R.P.) type faults have been investigated for Sr-excess SrTiO3 (STO) homoepitaxial thin films by pulsed laser deposition (PLD) and tuning of the laser fluence. The R.P. type fault structures were found to depend on the amount of excess Sr. The growth direction of the planer faults changed from normal to normal and parallel to the substrate surface with an increase in excess Sr. Due to the directional change of the planer faults, the out-of-plane lattice shows lattice expansion. The results suggest that we can control the planer fault structures in STO thin films simply by changing the laser fluence in the PLD method.
Highly luminescent silver indium sulfide (AgInS2) nanoparticles were synthesized by dropwise injection of a sulfur precursor solution into a cationic metal precursor solution. The two-step reaction including the formation of silver sulfide (Ag2S) nanoparticles as an intermediate and their conversion to AgInS2 nanoparticles, occurred during the dropwise injection. The crystal structure of the AgInS2 nanoparticles differed according to the temperature of the metal precursor solution. Specifically, the tetragonal crystal phase was obtained at 140 °C, and the orthorhombic crystal phase was obtained at 180 °C. Furthermore, when the AgInS2 nanoparticles were coated with a gallium sulfide (GaSx) shell, the nanoparticles with both crystal phases emitted a spectrally narrow luminescence, which originated from the band-edge transition of AgInS2. Tetragonal AgInS2 exhibited narrower band-edge emission (full width at half maximum, FWHM = 32.2 nm) and higher photoluminescence (PL) quantum yield (QY) (49.2%) than those of the orthorhombic AgInS2 nanoparticles (FWHM = 37.8 nm, QY = 33.3%). Additional surface passivation by alkylphosphine resulted in higher PL QY (72.3%) with a narrow spectral shape.