This research investigated the implementation of PhET simulation on students’ understanding and motivation in learning the Solar system. The method used in this research was quasi-experimental with matching pretest-posttest group design. The research conducted in one of private Junior High School located at Padalarang, Indonesia with a number of students (n=42). The sampling technique used was the purposive sampling to determine experimental group with PhET simulation in the learning science and control group without PhET simulation. The quantitative data of this research was obtained through the objective test on the mastery concept Solar system, while the qualitative data was detected through motivation rubric and questionnaire. The result shows that the students who learn the Solar system with PhET simulation have higher both improvement in conceptual understanding and motivation than without PhET simulation as teaching media. According to the analysis result, there is a moderate correlation between conceptual understanding and motivation with the learning Solar system in the use PhET simulation.
1 January 2017 in Spectrochimica Acta Part A: Molecular and Biomolecular Spectroscopy
This work contributes to combining 12.2 mM purified anthocyanin of cyanidin-3-glucoside extracted from Indonesian black rice as the natural pigment with a ruthenium photosensitizer (1 : 1) in dye-sensitized solar cells (DSSCs) in liquid and quasi solid-state electrolytes. The findings essentially highlight the spectroscopic and electron transfer mechanism for the future trend of D–π–A natural pigment modification. The complete pigment comparison, dye absorbance, dye adsorption onto the semiconductor, dye electronic properties, electron excitation, and regeneration were investigated using spectroscopic methods. Cells employ TiO2 mesoporous nanoparticles (19.18 nm grain size, 50.99 m2 g−1 surface area, 87.8% anatase 12.2% rutile, 10.58 μm thickness, 3.18 eV band gap) sensitized by anthocyanin-N719 photosensitizer (12.2 mM) with the I−/I3− electrolyte (0.1 M lithium iodide/0.05 M iodine/0.6 M 1-buty-3-methylimidazolium iodide/0.5 M 4-tert-butylpyridine/polyethylene oxide Mw = 1 × 106) – Pt film. As a result, the quasi-solid state with combined anthocyanin-ruthenium dye-sensitized solar cell (3.51%) is achieved and reported for the first time. The work also achieved the highest efficiency of the anthocyanin dye-sensitized quasi-solid state solar cells of 2.65%. The insight on how the combined anthocyanin-N719 and the quasi-solid state electrolytes exhibit better performances will be further discussed.
5 September 2016 in Indonesian Journal of Science and Technology
The present study investigated the photodecomposition of an organic material during the partial (88.76%) solar eclipse phenomenon of 9 March 2016 in Bandung, Indonesia. Curcumin and anatase titanium dioxide (TiO2) particles were used as models of organic material and photocatalyst, respectively. The influence of the process parameters (i.e., curcumin concentration and the amount of TiO2) on the photodecomposition process was also investigated. The results showed that the curcumin was decomposed along with the solar light irradiation time. During the solar eclipse, the photodecomposition rate is suddenly down. The partial solar eclipse provided a slower photodecomposition process than the process under sunny days (conducted on 8 and 10 March 2016). The concentration of curcumin and the amount of TiO2 also have played an important role in the photodecomposition, in which the lower concentration of curcumin and the higher amount of TiO2 have a correlation to the obtainment of higher photodecomposition rate.