Organic Electrochemical Transistors are versatile sensors that became essential for the field of organic bioelectronics. However, despite their importance, an incomplete understanding of their working mechanism is currently precluding a targeted design of Organic Electrochemical Transistors and it is still challenging to formulate precise design rules guiding materials development in this field. Here, it is argued that current capacitive device models neglect lateral ion currents in the transistor channel and therefore fail to describe the equilibrium state of Organic Electrochemical Transistors. An improved model is presented, which shows that lateral ion currents lead to an accumulation of ions at the drain contact, which significantly alters the transistor behavior. Overall, these results show that a better understanding of the interface between the organic semiconductor and the drain electrode is needed to reach a full understanding of Organic Electrochemical Transistors.
Recent steady-state and transient models of organic electrochemical transistors (OECTs) are summarized and used to discuss trends in the design of high-performance OECT materials.
20 February 2022 in Advanced Theory and Simulations
A fast response of organic electrochemical transistors (OECTs) to electrical or chemical changes is essential for a widespread acceptance of this technology. However, finding design rules for fast switching OECTs is complicated by the fact that current transient device models are highly simplified and rely on a 1D approximation of the device that neglects details of the ion and hole concentration inside the transistor channel. To improve the understanding of transient processes limiting the speed of OECTs, a 2D drift‐diffusion model is presented and experimentally validated. It is shown that switching is strongly influenced by lateral ion currents that are neglected in previous models. A consistent treatment of these currents leads to a dependency of the time constants on the applied drain potential and a complex dependency of the response time constants on the detailed device geometry. In addition to an improved understanding of the transient response of OECTs, the results discussed here highlight the challenges in properly characterizing switching time constants of OECTs, and reinforce the necessity to ensure that switching is measured between two steady‐state conditions, and not between transient states.
25 January 2022 in ACS Applied Materials & Interfaces
The first study of the flexo-ionic effect, i.e., mechanical deformation-induced electric signal, of the recently discovered ionic liquid crystal elastomers (iLCEs) is reported. The measured flexo-ionic coefficients were found to strongly depend on the director alignment of the iLCE films and can be over 200 µC/m. This value is orders of magnitude higher than the flexo-electric coefficient found in insulating liquid crystals and is comparable to the well-developed ionic polymers (iEAPs). The shortest response times, i.e., the largest bandwidth of the flexo-ionic responses, is achieved in planar alignment, when the director is uniformly parallel to the substrates. These results render high potential for iLCE-based devices for applications in sensors and wearable micropower generators.