Enhanced transparency, conductivity, and stability are some of the most important factors to consider in order to prepare transparent electrodes (TEs) and hole transport layer (HTL) for organic solar cells. In this study, the transparency, optical, and electrical behavior of hybrid films formed by poly(3,4-ethylenedioxythiophene):poly (styrenesulfonate) (PEDOT:PSS) and heptacoordinated organotin (IV) complexes was improved by introducing graphene. The films were deposited by spin-coating and subsequently characterized by infrared and Raman spectroscopy, and by scanning electron microscopy (SEM) and atomic force microscopy (AFM). All the hybrid films transmitted more than 70% of light in the 600–1,000 nm wavelength region, and the optical band gap obtained is in the range of 2.64 and 3.09 eV. In addition, bathophenanthroline (BPhen) was introduced as an electron transport layer (ETL) in order to study the solar cell with complete architecture, conformed by glass/ITO/PEDOT:PSS-graphene-complex/BPhen/Ag. By incorporating the BPhen, the J–V curve current density values were increased, showing a conductivity change of as much as 2.1 × 10−4 S/cm, and under illuminated conditions a more pronounced J–V curve variation (as much as 2.5 × 101 A/cm2) was observed. In closing, the devices were subjected to accelerated lighting conditions to determine the stability and operating capacity of the solar cells. The electrical behavior of the devices changed. Within the first 2 h, the electrical behavior improved, where the organotin complex without a substituent (complex-a) device presents higher stability than the complex with the chloride substituent (complex-b) device due to the chloride radical interacting with the BPhen. However, the electrical behavior degraded after 4 h almost eight orders of magnitude in current density due to device films and interface degradation.
Novel heterostructures based on ferrocenium hexafluorophosphate (FcPF6), 2,6-dihydroxyanthraquinone (DHAQ) or 2,6-diaminoanthraquinone (DAAQ), zinc phthalocyanine (ZnPc) and nylon 11 were deposited by the high-vacuum thermal evaporation (HVTE) technique. Morphological and mechanical characterizations of these organic heterostructures FcPF6:DHAQ/nylon(ZnPc) and FcPF6:DAAQ/nylon(ZnPc) were carried out. Subsequently, corresponding optical parameters were calculated. The heterostructure with FcPF6:DHAQ presented the lowest optical band gap and fundamental band gap at 1.55 eV and 2.45 eV, respectively. The nylon(ZnPc) layer favors the optical behavior and places these heterostructures within organic low-bandgap semiconductor range. Additionally, devices were fabricated, and their electrical behavior was evaluated. The ITO/FcPF6:DHAQ/nylon(ZnPc)/Ag device exhibits ohmic behavior, and the ITO/FcPF6:DAAQ/nylon(ZnPc)/Ag device exhibits ohmic behavior at low voltages, but at V ≥ 5 V, its behavior changes to Space Charge Limited Current (SCLC). This device carries a maximum current of 0.02 A, three orders of magnitude higher than the current carried by the device with the DHAQ. The SCLC conduction mechanism showed a hole mobility of 9.27 × 10−8 (cm2)/Vs, the concentration of thermally excited holes of 3.01 × 1023 m−3, and trap concentration of 3.93 × 1021 m−3. FcPF6:DHAQ/nylon(ZnPc) and FcPF6:DAAQ/nylon(ZnPc) are potential candidates for organic devices as an emitter layer and active layer, respectively.