The anti-slide pile is a primary method of landslide control. The effect of the passive soil arch in front of the embedded section of piles has a significant effect on the anti-slide pile’s bearing capacity. The upgraded model test scheme was used to conduct model tests with a pile spacing four times the width of the pile and a geometric scale ratio of 1:15. The anti-slide pile stress, pile bending strain, and soil stress in front of the pile were all studied in relation to the loading amount. In addition to the model test, the numerical simulation method was utilized to investigate the three-dimensional morphological change of the passive soil arch in front of the pile. The results indicated that: clearly, the side piles can eliminate the border effect. The distribution of pile bending strain along the pile after loading is referred to as a parabola. Bending failure occurred at a depth of 40 mm, approximately 0.9 m from the pile top. Under the condition that the pile spacing is four times the pile width, a passive soil arch occurs in front of the anti-slide pile’s fixed part, and its development can be split into four stages: formation, development, completion, and destruction. The passive soil arches in front of the piles are generated and destroyed gradually along the buried depth, and the three-dimensional surface of the space drops gradually along the buried depth with the loading amount and advances toward the loading direction until the anti-slide pile system fails. The research findings and experiences can serve as a basis for future research.
A ground fissure is a geological disaster in which the vertical dislocation of strata causes surface rupture. Ground fissures can cause extreme harm to the surface and underground buildings. Ground fissure activity can result in different settlement on the two sides of the strata, which will generate additional stress (pressure) that differs from the stress of the general stratum on underground structures across the ground fissure zone. It is essential to assess the effective stress of strata in the design of underground engineering structures across a ground fissure zone. The Xi’an ground fissure through a utility tunnel was focus of the research, and a physical model and data for oblique crossing of the 45° ground fissure were analyzed. A model of the utility tunnel structure was established, including the surrounding soil load as an active ground fissure environment. This model was used to calculate the vertical formation pressure of the overlying soil on the utility tunnel. A method to calculate the overlying load on the utility tunnel caused by ground fissure activity was proposed and compared with the calculation based on the A. Marston principle. The results showed that the ground fissure load calculation method based on the strata-holding effect can effectively calculate the earth pressure of the surrounding soil layer of the utility tunnel in the cross-ground fissure section. The results of this work provide guidance and reference value for the design of a utility tunnel in an area with the potential for a ground fissure.
About Me
Ph.D. Candidate, mainly engaged in underground structure and geotechnical engineering. Email:renxiang@chd.edu.cn
Ph.D. Candidate, mainly engaged in underground structure and geotechnical engineering. Email:renxiang@chd.edu.cn