Michał Turski

Dr. Michał Turski

Department of Sanitary Networks and Installations, Faculty of Infrastructure and Environment, Czestochowa University of Technology, Czestochowa 42-200, Poland
orcid

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 November 2018 in Energy and Buildings
Verified
Journal Article
Closed access
Michał TurskiMichał Turski
Michał Turski
RSRobert Sekret
Robert Sekret

1 August 2012 in Energy and Buildings
Verified
Journal Article
Closed access
RSRobert Sekret
Robert Sekret
Michał TurskiMichał Turski
Michał Turski

1 November 2019 in Energy
Verified
Journal Article
Closed access
Michał TurskiMichał Turski
Michał Turski
KNKinga Nogaj
Kinga Nogaj
RSRobert Sekret
Robert Sekret

9 August 2022 in Energies
Verified
Journal Article
Open access
PDF file
Michał TurskiMichał Turski
Michał Turski
AJAgnieszka Jachura
Agnieszka Jachura
The wide use of energy-efficient district heating systems allows for decreased atmospheric pollution resulting from lower emissions. One of the ways to increase the efficiency of existing district heating systems, and a key element of new systems using renewable energy sources, is modern heat storage technology—the utilization of dispersed PCM heat accumulators. However, the use of different solutions and the inconsistency of selection methods make it difficult to compare the obtained results. Therefore, in this paper, using TRNSYS software, a standardization of the selection of dispersed PCM heat accumulators for cooperation with buildings in the DHS was proposed along with a Life Cycle Assessment. Life Cycle Assessment could be a good, versatile indicator for new developments in district heating systems. A new contribution to the research topic was the Life Cycle Assessment itself as well as the range of heat output of the substations up to 2000 kW and the development of nomograms and unitary values for the selection of individual parameters based on the relative amount of heat uncollected by buildings. The technical potential of heat storage value, %ΔQi,st, was from 49.4% to 59.6% of the theoretical potential of heat storage. The increases in the active volume of the PCM heat accumulator, dVPCM, and the mass of the required amount of PCM, dmst, were, respectively, 0.8 × 10−2–4.0 m3/kW and 1.3–6.7 × 10−2 kg/kW. Due to dispersed heat storage, an increase in system efficiency of 41% was achieved. LCA analysis showed that a positive impact on the environment was achieved, expressed as negative values of the Eco-indicator from −0.504 × 10−2 to −6.44 × 10−2 kPt/kW.

3 July 2018
Verified
Conference Paper
Open access
Michał TurskiMichał Turski
Michał Turski
In financing mechanism of National Fund for Environmental Protection and Water Management it is necessary to achieve energy savings of at least 20%. However, not always achieving such energy savings means an increase in economic and ecological efficiency. Therefore, the article presents possibilities of investment leading to energy savings, reducing consumption of primary energy contained in the fuel by increasing production efficiency and reducing energy losses directly in the source. This solution will allow to keep economic and ecological savings. Proposed solutions are crucial for the implementation of investment. The improvements proposed in the article, if they have not been implemented so far, should give significant effects in all cases. The study was conducted for the medium-sized Polish company. The company can be considered as representative of food processing industry. The study was conducted on basis of energy efficiency auditing. Based on the obtained results it can be stated that the use of cogeneration, heat recovery and alternative methods of cooling at an appropriate balancing may allow the average annual primary energy saving of 563 toe/year and the reduction in CO2 emissions by 2,413 t/year. Thus achieved energy efficiency index may reach approx. 20%, eco-efficiency index may reach approx. 40% and economic efficiency index may reach approx. 30%.

1 June 2016 in Chemical and Process Engineering: New Frontiers
Verified
Journal Article
Open access
PDF file
Michał TurskiMichał Turski
Michał Turski
RSRobert Sekret
Robert Sekret
This paper presents the possibility of reducing the demand for nonrenewable primary energy for buildings using a new conceptual adsorption system of cooling and heating supplied by solar energy. Moreover, the aim of this study is to shorten the payback time of investment in the standard adsorption cooling system through its integration with the heating system. Research has been carried out for an energy-efficient medium-sized single-family building with a floor area of 140 m2 and a heat load of 4.2 kW and cold load of 4.41 kW. It has been shown that the use of an adsorption system of cooling and heating supplied by solar energy decreased the demand for nonrenewable primary energy by about 66% compared to the standard building that meets the current requirements.