This state-of-knowledge review examines some of the underlying assumptions and limitations associated with the inter-relationships among four widely used descriptors of surface fire behaviour and post-fire impacts in wildland fire science and management, namely Byram’s fireline intensity, flame length, stem-bark char height and crown scorch height. More specifically, the following topical areas are critically examined based on a comprehensive review of the pertinent literature: (i) estimating fireline intensity from flame length; (ii) substituting flame length for fireline intensity in Van Wagner’s crown fire initiation model; (iii) the validity of linkages between the Rothermel surface fire behaviour and Van Wagner’s crown scorch height models; (iv) estimating flame height from post-fire observations of stem-bark char height; and (v) estimating fireline intensity from post-fire observations of crown scorch height. There has been an overwhelming tendency within the wildland fire community to regard Byram’s flame length–fireline intensity and Van Wagner’s crown scorch height–fireline intensity models as universal in nature. However, research has subsequently shown that such linkages among fire behaviour and post-fire impact characteristics are in fact strongly influenced by fuelbed structure, thereby necessitating consideration of fuel complex specific-type models of such relationships.
18 June 2012 in International Journal of Wildland Fire
A mathematical model is presented for predicting the maximum potential spot fire distance from an active crown fire. This distance can be estimated from the height of the flame above the canopy top, wind speed at canopy-top height and final firebrand size (i.e. its residual size on alighting), represented by the diameter of a cylinder of woody char. The complete model system comprises several submodels or components: a model for the height and tilt angle of the wind-blown line-fire flame front, a simplified two-dimensional model of the wind-blown buoyant plume from the fire, an assumed logarithmic wind speed variation with height, and an empirically based model for the burning rate of a wooden cylinder in cross flow, which represents the firebrand. The trajectory of the burning particle is expressed analytically from where it leaves the lower boundary of the plume until it enters the canopy top. Adding the horizontal distance of this flight to that of the point where the particle can no longer be held aloft by the plume flow gives a spotting range that depends on the final diameter of the burning particle. Comparisons of model output with existing information on crown fire spotting distances has initially proved encouraging but further evaluation is warranted.
5 July 2012 in International Journal of Wildland Fire
A methodology has been developed for defining the various threshold conditions required for the opening of serotinous cones and viable seed release in the overstorey canopies in jack pine (Pinus banksiana) and lodgepole pine (Pinus contorta var. latifolia) forests on the basis of fireline intensity and, in turn, rate of fire spread and fuel consumption. The extent of the effects to the overstorey canopy (i.e. crown scorch height and flame defoliation) and the type of fire (i.e. low- to high-intensity surface, intermittent crown and active crown) vary at any given fireline intensity level and are principally a function of foliar moisture content, canopy base height, stand height and canopy bulk density. The viability of the seed stored in serotinous cones of the two pine species begins to decreases once the flame-front residence time at the ground level of an active crown fire exceeds 50 s.
An analysis of a dataset (n = 58) of high-intensity wildfire observations in cured grasslands from southern Australia revealed a simple relationship suitable for quickly obtaining a first approximation of a fire’s spread rate under low dead fuel moisture contents and strong wind speeds. It was found that the forward rate of fire spread is approximately 20% of the average 10-m open wind speed. The data on rate of fire spread and 10 m open wind speed ranged from 1.6 to 17 and 20 to 62 km h−1, respectively. The validity of the resulting rule of thumb was examined across a spectrum of burning conditions and its performance was contrasted against that of established empirical-based fire spread models for three different grassland fuel conditions currently used operationally in Australia. The 20% rule of thumb for grassfires produced error statistics comparable to that of the fire spread rate model for grazed or cut grass fuel conditions as recommended for general use during the summer fire season in southern Australia.
The recent mountain pine beetle outbreak affecting lodgepole pine forests in the Rocky Mountains has created a novel fire environment for wildland firefighters. This paper presents results from an examination of firefighters’ observations of fire behavior in post-outbreak lodgepole pine forests, with a focus on what they considered surprising from a fire behavior standpoint and how this in turn affected their suppression tactics. The surprises in fire behavior experienced by firefighters during the red phase of post-outbreak forests included an elevated level of fire spread and intensity under moderate weather and fuel moisture conditions, increased spotting, and faster surface-to-crown fire transitions with limited or no ladder fuels. Unexpectedly, during the gray phase in mountain pine beetle-attacked stands, crown ignition and crown fire propagation was observed for short periods of time. Firefighters are now more likely to expect to see active fire behavior in nearly all fire weather and fuel moisture conditions, not just under critically dry and windy situations, and across all mountain pine beetle attack phases, not just the red phase. Firefighters changed their suppression tactics by adopting indirect methods due to the potential fire behavior and tree-fall hazards associated with mountain pine beetle-attacked lodgepole pine forests.