Bogusław Hościło

Dr. Bogusław Hościło

Bialystok University of Technology, Faculty of Mechanical Engineering

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
25 June 2021 in Sensors
Verified
Journal Article
Open access
PDF file
PMPiotr Mrozek
Piotr Mrozek
Ewa GorodkiewiczEwa Gorodkiewicz
Ewa Gorodkiewicz
Pawel FalkowskiPawel Falkowski
Pawel Falkowski
BHBogusław Hościło
Bogusław Hościło
Comparative analysis of the sensitivity of two surface plasmon resonance (SPR) biosensors was conducted on a single-metallic Au sensor and bimetallic Ag–Au sensor, using a cathepsin S sensor as an example. Numerically modeled resonance curves of Au and Ag–Au layers, with parameters verified by the results of experimental reflectance measurement of real-life systems, were used for the analysis of these sensors. Mutual relationships were determined between ∂Y/∂n components of sensitivity of the Y signal in the SPR measurement to change the refractive index n of the near-surface sensing layer and ∂n/∂c sensitivity of refractive index n to change the analyte’s concentration, c, for both types of sensors. Obtained results were related to experimentally determined calibration curves of both sensors. A characteristic feature arising from the comparison of calibration curves is the similar level of Au and Ag–Au biosensors’ sensitivity in the linear range, where the signal of the AgAu sensor is at a level several times greater. It was shown that the influence of sensing surface morphology on the ∂n/∂c sensitivity component had to be incorporated to explain the features of calibration curves of sensors. The shape of the sensory surface relief was proposed to increase the sensor sensitivity at low analyte concentrations.

29 October 2020 in Materials
Verified
Journal Article
Open access
PDF file
BHBogusław Hościło
Bogusław Hościło
KMKrzysztof L. Molski
Krzysztof L. Molski
The paper presents a method for estimating the value of equibiaxial stress in a surface layer of a material by using a modified hardness measurement procedure with a Vickers indenter. A certain characteristic parameter was defined and related to the surface stress. A hybrid approach, based on experimental tests and accompanied by the complementary results obtained by the finite element modelling of X20Cr13 steel in elastic–plastic range, confirmed a linear relationship between the value of the characteristic parameter and the magnitude of equibiaxial stress at the surface. This linear relationship was valid in both elastic and elastic–plastic strain range beyond the yield stress of the material.

15 May 2024 in Materials
Verified
Journal Article
Open access
PDF file
BHBogusław Hościło
Bogusław Hościło
KMKrzysztof L. Molski
Krzysztof L. Molski
The paper presents an analysis of the low-cycle fatigue (LCF) properties of C45, X20Cr13, and 34CrNiMo6 steels subjected to various heat treatment processes. Strain-controlled LCF tests were carried out with a total cyclic strain amplitude equal to 0.5, 1 and 1.5%. Fatigue life, cyclic stress-strain behavior and hardness were analyzed. Qualitative and quantitative relationships between material LCF properties resulting from the heat treatment processes, were related to the indentation force P*, which was derived experimentally by applying an instrumented indentation procedure with the use of the Vickers indenter. The proposed parameter P* and its changes ΔP* seem to be promising for the identification of the structural stress parameter σ* that is necessary for deriving values of the fatigue strength coefficients σf’ corresponding to different tempering temperatures. The common feature of all steels analyzed in this paper is that the elastic parts of the strain-life characteristics remain parallel after being subjected to different tempering temperatures.