This paper reports the synthesis of silver nanoparticles coated with porous silica (Ag@Silica NPs) using an assisted laser ablation method. This method is a chemical synthesis where one of the reagents (the reducer agent) is introduced in nanometer form by laser ablation of a solid target submerged in an aqueous solution. In a first step, a silicon wafer immersed in water solution was laser ablated for several minutes. Subsequently, an AgNO3 aliquot was added to the aqueous solution. The redox reaction between the silver ions and ablation products leads to a colloidal suspension of core-shell Ag@Silica NPs. The influence of the laser pulse energy, laser wavelength, ablation time, and Ag+ concentration on the size and optical properties of the Ag@Silica NPs was investigated. Furthermore, the colloidal suspensions were studied by UV–VIS-NIR spectroscopy, X-Ray diffraction, and high-resolution transmission electron microscopy (HRTEM).
Phase transitions and structural and magnetic properties of rapidly solidified Ni50Mn38Sn12 alloy ribbons have been studied. Ribbon samples crystallize as a single-phase, ten-layered modulated (10M) monoclinic martensite with a columnar-grain microstructure and a magnetic transition temperature of 308 K. By decreasing the temperature, martensite undergoes an intermartensitic phase transition around 195 K. Above room temperature, the high temperature martensite transforms into austenite. Below 100 K, magnetization hysteresis loops shift along the negative H-axis direction, confirming the occurrence of an exchange bias effect. On heating, the thermal dependence of the coercive field HC shows a continuous increase, reaching a maximum value of 1017 Oe around 50 K. Above this temperature, HC declines to zero around 195 K. But above this temperature, it increases again up to 20 Oe falling to zero close to 308 K. The coercivity values measured in both temperature intervals suggest a significant difference in the magnetocrystalline anisotropy of the two martensite phases.
1 August 2018 in Spectrochimica Acta Part B: Atomic Spectroscopy
We implement a whispering-gallery-mode microbubble resonator (MBR) as a multifunctional component for all-optical photoacoustic inspection of materials in a platform combining microfluidic design and high sensitivity to spectral absorbance. In our setup, the MBR acts both as the acoustic transducer and as the vial for a sample causing the photoacoustic event, thus dictating its operational frequency and removing any need for impedance-matching media. We challenge our setup in the assessment of the photostability of gold nanorods to demonstrate its validity. We develop a numerical model to qualitatively interpret the experimental signal as a transient shift of the resonance condition of the MBR. Possible implementations of the MBR in photoacoustic sensors are discussed.