Although water availability depends both on qualitative and quantitative aspects, most studies focus only on one of these. Therefore, the goal here is to relate water quality and quantity with the construction of Load Duration Curves (LDC) and to estimate E. coli load patterns in different flow conditions, seasons, and positions of two sub-basins of the Doce watershed (Brazil): Piracicaba and Piranga. A novel methodology is proposed in which the Burr XII distribution is adjusted to the LDC to compare all observed loads to their respective Total Maximum Daily Load (TMDL), allowing the estimation of the relative difference (RD) between these. Higher values of RD were observed for low flows for the Piracicaba basin, more urbanized, where point sources of pollution are the primary concern, reaching up to 99% of needed load reduction. In the Piranga basin, more agricultural, there was a broader RD variation, from 9% to 97% load reduction needed, which is an evidence of point sources of pollution combined with non-point sources. The new methodology can be used to estimate the load reduction of any pollutant and can be used by environmental agencies to identify effective practices to minimize and control pollution in different locations of the basins.
Almost every researcher has come through observations that “drift” from the rest of the sample, suggesting some inconsistency. The aim of this paper is to propose a new inconsistent data detection method for continuous geospatial data based in Geostatistics, independently from the generative cause (measuring and execution errors and inherent variability data). The choice of Geostatistics is based in its ideal characteristics, as avoiding systematic errors, for example. The importance of a new inconsistent detection method proposal is in the fact that some existing methods used in geospatial data consider theoretical assumptions hardly attended. Equally, the choice of the data set is related to the importance of the LiDAR technology (Light Detection and Ranging) in the production of Digital Elevation Models (DEM). Thus, with the new methodology it was possible to detect and map discrepant data. Comparing it to a much utilized detections method, BoxPlot, the importance and functionality of the new method was verified, since the BoxPlot did not detect any data classified as discrepant. The proposed method pointed that, in average, 1,2% of the data of possible regionalized inferior outliers and, in average, 1,4% of possible regionalized superior outliers, in relation to the set of data used in the study.