Sam Green

Dr. Sam Green

orcid

Research Focus & Metrics

Academic Career Length

17Years (2010-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
24 February 2011 in Journal of the Geological Society
Verified
Journal Article
Closed access
ERErnest Rutter
Ernest Rutter
SGSam Green
Sam Green
The Mam Tor landslide (Derbyshire, England) slips downhill at up to 0.5 m a −1 , and offers an excellent opportunity to study time-dependent creep in mudstones under in situ conditions. Annual surveys show that creep rates increase following heavy rainfall, but to establish detailed correlation between creep and pore water pressure required spatially and temporally higher resolution monitoring. We acquired 3 years of such data, at 3 h intervals, from wire creep meters, borehole piezometers and rainfall monitoring, showing that creep is strongly focused into the winter months and correlates well with pore water pressure. Summer grass and fern growth strongly influence rainfall infiltration, recycling much of the rainfall back to the atmosphere, explaining the seasonal variability of creep. The dependence of creep rate on pore pressure can be recast as a rheological model relating shear strain rate to shear stress using the friction angle for the creeping mudstone to link effective normal stress to shear stress. The creep is very non-linear, following a power law with a stress exponent of 48. This flow law may apply also to shear failure in poorly consolidated mudrocks under high pore pressure conditions; for example, within some landslides, subglacial sediments, tectonic fault zones, tectonic mélanges and accretionary complexes.

1 January 2019 in The Leading Edge
Verified
Journal Article
Closed access
ENEhsan Zabihi Naeini
Ehsan Zabihi Naeini
SGSam Green
Sam Green
IRIestyn Russell-Hughes
Iestyn Russell-Hughes
MRMarianne Rauch-Davies
Marianne Rauch-Davies
In unconventional plays, wells are drilled at an unprecedented rate. This, together with technical challenges in terms of complex stratigraphy, multiple play types, variable rock properties, and various elements of pore pressure, geomechanics, fracturing, and diagenesis, calls for more sophisticated, faster, consistent, and wider ranging analytical tools. Given the scale of the work — i.e., the number of wells — performing classical workflows for petrophysics, pore pressure, and geomechanics prediction can be impractical (if not impossible) due to turnaround considerations. Also such workflows might not use any preexisting regional studies efficiently. In principle, a machine learning approach can mitigate these shortcomings. We show that a supervised deep neural network approach can be an alternative innovative tool for petrophysical, pore pressure, and geomechanics analysis enabling the use of all the previously interpreted data to devise solutions that simultaneously integrate wide-ranging wellbore and wireline logs. Beyond that, a similar approach is taken to predict a certain number of attributes solely from seismically derived properties, which allows one to compute volumetric models. The application of such an algorithm is shown on a Permian case study in which the automatic neural-network-based algorithms achieve reasonable accuracy in a fraction of the time.

12 May 2020 in Geophysical Prospecting
Verified
Journal Article
Closed access
PDF file
SGSam Green
Sam Green
LVLev Vernik
Lev Vernik

5 May 2014
Verified
Conference Paper
Closed access
PDF file
SGSam Green
Sam Green
RSRichard E. Swarbrick
Richard E. Swarbrick
SOStephen A. O'COnnor
Stephen A. O'COnnor
Hydrodynamically active reservoirs have been recognized in various parts of the world. The majority of these are termed "conventional", following the nomenclature presented in Swarbrick (2009), whereby fluid flow is driven by hydraulic head. More recently "unconventional" hydrodynamic reservoirs have been recognized where fluid flow is driven by lateral drainage, typically found in laterally extensive reservoirs. The lateral drainage of pressure in reservoir sand units leads to a pressure gradient from higher pressured non-reservoir sediments (shales) above and below into the reservoir, leading to a focus of fluids, including hydrocarbons, within the reservoir. Within a laterally extensive reservoir fill and spill up-dip is likely to dominate the trapping of hydrocarbons, which is typically assisted by hydrodynamic flow as the aquifer will drain up-dip. Hence, secondary migration along extensive sand units is a highly effective carrier system, with little/no potential for vertical migration of hydrocarbons since there are higher pressures above and below. Hydrocarbon column heights can extend above the limits imposed by capillary entry pressures on account of the higher water pressures in the sealing rocks relative to the aquifer pressures in the sands. Such reservoirs are present in the Miocene of the Gulf of Mexico and there are multiple sources of evidence for active "unconventional" hydrodynamics which are summarized within this paper. Furthermore, new data is presented that indicates the deeper Lower Tertiary Wilcox play is hydrodynamically active by combining direct pressure data interpretation with the geological depositional model.

13 July 2010 in Geology Today
Verified
Journal Article
Closed access
PDF file
SGSam Green
Sam Green
ERErnest Rutter
Ernest Rutter
RHRobert Holloway
Robert Holloway

27 August 2018
Verified
Conference Paper
Closed access
SGSam Green
Sam Green
JMJeremy Meyer
Jeremy Meyer
MRMarianne Rauch-Davies
Marianne Rauch-Davies
SSSteve Smith
Steve Smith
BSBob Schmicker
Bob Schmicker
Pore pressure is a critical input to a geomechanical model and impacts the mechanical stability of a well. It is also desirable to map the high pressure areas before drilling decisions are made as wells that intersect these zones are typically more prolific producers. A well-based workflow was developed that was able to predict the recorded pore pressure and then calibrate a geomechanical model which matched the wellbore measurements. This model was then tested on wells with the requisite log dataset and was able to replicate the observed mechanical wellbore behavior, highlighting the accuracy of the pore pressure prediction. The resultant models were then applied to a high resolution 3D seismic inversion encompassing key elastic properties and facies prediction to produce a 3D understanding of the distribution of pressure and stress. Presentation Date: Monday, October 15, 2018 Start Time: 1:50:00 PM Location: 206A (Anaheim Convention Center) Presentation Type: Oral