Cast irons are known to be easy to shape by sand casting due to their high eutectic fraction. Despite this fact, together with cost benefits, obtaining good quality castings is not an easy task, although it depends on the level of defects allowed in each case. Casting defects are here reviewed and classified into three classes according to their known main origin: (1) related to the sand mixtures used to make the molds; (2) associated with the mold design and the geometry of the castings; (3) related to the casting alloy itself. The present work is an illustrated description of these defects, with details of their origin when well established, and of known remedies. In addition, an attempt has been made to clarify the possible cross-effects of the above three origins.
16 January 2009 in Metallurgical and Materials Transactions A
In a previously published work, pearlite growth in cast irons was investigated and it was claimed that growth kinetics of pearlite in nodular cast iron does not depend on alloying elements and that only the start temperature for the transformation is modified. Since then, the authors have investigated the effect of copper at low level of manganese and the combined effect of copper and tin at intermediate manganese contents. In the first case, thermal records confirmed that copper decreases the formation temperature for both ferrite and pearlite. In the second work, an optimised content for tin, manganese and copper was found so as to improve mechanical properties while keeping fully pearlitic structures. The thermal records obtained during this latter study are here used to estimate the pearlite growth kinetics and the effect of copper and tin on it. Tin has been shown to reduce pearlite undercooling (increase of start transformation temperature) and thus to favour the formation of this constituent.
10 November 2016 in International Journal of Materials Research
Use of rare earths, high silicon and carbon contents, and low cooling rates are reported as possible reasons for formation of chunky graphite in ductile iron castings. The understanding of this graphite degeneration is however limited, and the above conclusions are still controversial. To get further insight into this topic, ductile cast iron melts have been prepared with various carbon and silicon contents and using nodularizing alloys with various rare earth levels. These melts have been cast in blocks with different sizes to include also the effect of cooling rate on graphite degeneration. Metallographic investigation revealed that the chunky-affected areas enlarge when decreasing the cooling rate, when increasing the silicon content and without low-level addition of rare earth. In the discussion, a schematic based on change of liquid/graphite interfacial energy with alloying elements is proposed which describes the conditions for the formation of chunky graphite instead of nodular graphite.
28 September 2012 in Transactions of the Indian Institute of Metals