In this work, we report the design of ceramic lattices produced via additive manufacturing (AM) used to improve the overall performances of compact, high temperature heat exchangers (HXs). The lattice architecture was designed using a Kelvin cell, which provided the best compromise among effective thermal conductivity, specific surface area, dispersion coefficient and pressure loss, compared to other cell geometries. A material selection was performed considering the specific composition of the fluids and the operating temperatures of the HX, and Silicon Carbide (SiC) was identified as promising materials for the application. The 3D printing of a polymeric template combined with the replica method was chosen as the best manufacturing approach to produce SiC lattices. The heat transfer behaviour of various lattice configurations, based on the Kelvin cell, was determined through computational fluid dynamics (CFD). The results are used to discuss the application of such structures to compact high temperature HXs.
Single-tank thermal energy storage (TES) systems represent not only a valuable alternative to the most commonly exploited two-tank configuration in conventional concentrating solar power (CSP) plants, but also the most suitable solution for air-based solar systems. The first parabolic trough CSP pilot plant (3.9 MWth peak), which uses air as heat transfer fluid (HTF), has been constructed in Ait-Baha Morocco. An important characteristic of this plant is the integration of a 100 MWhth TES unit based on a packed bed of gravel as storage medium. The TES unit is designed for daily operating conditions of 10 h of charging followed by 4.5 h of discharging, at higher HTF mass flow rate, and 9.5 h of idle. The nominal charging and discharging temperatures are 570°C and 270°C respectively. A previously validated computational fluid dynamics (CFD) approach was followed to evaluate the thermo-fluid dynamics behavior of the TES unit under investigation subjected to a total of 5 pre-charging cycles, to reduce the initial transients of the system, followed by 60 consecutive cycles. The TES performance was also evaluated on the basis of the first- and the second-law of thermodynamics. According to the simulation results, despite a relatively weak thermal stratification was observed into the packed bed, the TES performance showed an increase with cycles from 52% and 63% up to stable values of 90% and 88% for the energy and the exergy efficiencies respectively.
1 October 2021 in Chemical Engineering Research and Design
The concept of combined sensible/latent heat thermal energy storage (TES) has been exploited to mitigate an intrinsic thermocline TES systems drawback of heat transfer fluid outflow temperature reduction during discharging. In this study, the combined sensible/latent TES prototype under investigation is constituted by a packed bed of rocks and a small amount of encapsulated phase change material (AlSi12) as sensible heat and latent heat sections respectively. The thermo-fluid dynamics behavior of the combined TES prototype was analyzed by means of a computational fluid dynamics approach. Due to the small value of the characteristic vessel-to-particles diameter ratio, the effect of radial void-fraction variation, also known as channeling, was accounted for. Both the sensible and the latent heat sections of the storage were modeled as porous media under the assumption of local thermal non-equilibrium (LTNE). The commercial code ANSYS Fluent 15.0 was used to solve the model’s constitutive conservation and transport equations obtaining a fairly good agreement with reference experimental measurements.