Strategic plans for waste management require information on the current and future waste generation as a primary data source. Over the years, various approaches and methods for waste generation modeling have been presented and applied. This review provides a summary of the tasks that require information on waste generation that are most frequently handled in waste management. It is hypothesized that there is not currently a modeling approach universally suitable for forecasting any fraction of waste. It is also hypothesized that most models do not allow for modeling different scenarios of future development. Almost 360 publications were examined in detail, and all of the tracked attributes are included in the supplementary. A general step-by-step guide to waste generation forecasting, comprising data preparation, pre-processing, processing, and post-processing, was proposed. The problems that occurred in the individual steps were specified, and the authors’ recommendations for their solution were provided. A forecasting approach based on a short time series is presented, due to insufficient options of approaches for this problem. An approach is presented for creating projections of waste generation depending on the expected system changes. Researchers and stakeholders can use this document as a supporting material when deciding on a suitable approach to waste generation modeling or waste management plans.

Combined heat and power stations have become one of the most utilized units of district heating systems. These stations usually contain several boilers for burning fossil fuels and renewable resources used for heating up steam, which can be used either for residential and commercial heating or electricity generation. To ensure efficiency, a boiler should either run continuously (for at least a given period) on a power output higher than a given threshold or switch off. The optimal control of the plant operations should combine an efficient setup for the turbine and boilers in operation, reflecting the demand for steam and the price of electricity, and a schedule that describes which boilers should be in operation at a given time. This paper proposes a method for optimal control of combined heat and power station operation for a given time horizon. The method is based on a two-level approach. The lower-level models correspond to finding the optimal setup of the combined heat and power station parameters for an hourly demand for different kinds of steam. The upper-level model corresponds to the optimal schedule of the operations of the individual boilers, which is planned for the entire time horizon. The lower-level model is modeled as a mixed-integer linear programming problem and is solved using parametric programming. A dynamic programming algorithm solves the upper-level model with a rolling horizon. The validity of the proposed method and its computational complexity for different granularity of the time horizon, different ranges of the parameters, varying demand for various kinds of steam, and varying electricity prices are investigated in a case study. The presented approach can be readily applied to other control problems with a similar structure.