We perform a comprehensive detection of early aftershocks following the 2013 Mw 6.6 Lushan earthquake, which occurred in the southern Longmenshan Fault Zone in Sichuan Province, China, about 5 years after the 2008 Mw 7.9 Wenchuan earthquake. We use events in both standard and relocated catalogs as templates to scan through continuous waveforms 2 days before and 3 days after the main shock. We successfully reduce the magnitude of completeness Mc by more than 1 order and obtain up to 6 times more events than listed in both catalogs. Aftershocks in the first hour mostly occur around the main shock slip region, and aftershocks at later times show systematic expansions in the along‐strike, perpendicular‐strike, and updip directions. Although postseismic deformation following the Lushan main shock has not been clearly identified, we suggest that early aftershock expansions are likely driven by afterslip of the Lushan main shock. This is consistent with the observations that most aftershocks were in the stress shadow of the Lushan main shock and that there was significant slip deficit in the top 10 km of the crust. We also find that seismicity on the back thrust fault was activated as soon as 20 min after the main shock, earlier than previously reported. We are unable to detect any clear foreshocks in the last 2 days before the Lushan main shock.
An azimuth‐dependent dispersion curve inversion (ADDCI) method is applied to Rayleigh waves to extract 3D velocity and azimuthal anisotropy. The synthetic tests show that the ADDCI method is able to extract azimuthal anisotropy at different depths. The errors of the fast propagation direction (FPD) and the magnitude of the anisotropy (MOA) are less than 10° and 1–2%, respectively. The 3D anisotropic model shows large variations in the FPDs and MOAs with depth and blocks; strong contrasts are observed across major faults, and the average MOA in the crust is approximately 3%. The FPDs are positively correlated with the GPS velocity direction and the strikes of regional faults in most of the blocks. The low‐velocity zones (LVZs) in middle to lower crust are widely observed in the Songpan‐Ganze terrane, the north Chuan‐Dian block, and surprisingly in the Huayingshan thrust and fold belt. The LVZs in middle crust are also positively correlated with a region of low velocities in the uppermost mantle. These observations may suggest that large‐scale deformation is coupled vertically from surface to uppermost mantle. Crust shortening by the pure shearing process, which involves the thrusting and folding of the upper crust and the lateral extrusion of blocks, may be the major mechanism causing the growth of the eastern Tibetan Plateau.
We conduct a systematic survey on locally triggered earthquakes by large distant earthquakes in Changbaishan Volcano, an active intraplate volcano on the border between China and North Korea. We examine waveforms of distant earthquakes recorded at broadband station Changbaishan (CBS) near the volcano with estimated dynamic stresses over 5 kPa between 2000 and 2016. Out of 26 selected distant earthquakes, three of them show positive evidence of triggering during large‐amplitude surface waves. The earthquakes that had positive or possible evidences of triggering generated larger long‐period surface waves, indicating that they are more efficient in triggering microseismicity. In addition, since 2006 North Korea has conducted five underground nuclear explosion (UNE) tests only ~140 km away from Changbaishan Volcano. By systematically examining waveforms of these UNEs recorded at station CBS, we find that none of them have triggered microearthquakes in Changbaishan Volcano.