There are many moving machine assemblies with conformal tribological contacts at very high contact pressures, e.g., sliding bearings, propeller shaft bearings and machine guideways. Furthermore, applications such as trunnion and guide vane bearing in Kaplan turbines have very low sliding speeds and oscillatory types of motion. Although there is a vast selection of tribology test rigs available, there is still a lack of test equipment to perform friction and wear tests under high contact pressure, reciprocatory sliding and large area contact. The aim of this work is thus to develop a novel reciprocating tribometer and test method that enables friction and wear tests under low-speed reciprocatory sliding with contact pressures up to 90 MPa in a flat-on-flat contact configuration. First, a thorough description of the test rig design is given. Secondly, the influence of contact pressure and stroke length on the tribological properties of a stainless steel and polymer composite material combination is studied. The significance of considering creep, friction during the stroke and contact temperature is specifically highlighted. The novel tribometer can be used to screen different bearing and shaft material combinations and to evaluate the friction and wear performance of self-lubricating bearings for the specific operating conditions found in Kaplan turbines.

Press hardening is employed in the automotive industry to produce advanced high-strength steel components for safety and structural applications. This hot forming process depends on friction as it controls the deformation of the sheet. However, friction is also associated with wear of the forming tools. Tool wear is a critical issue when it comes to the dimensional accuracy of the produced components and it reduces the service life of the tool. It is therefore desirable to enhance the durability of the tools by studying the influence of high contact pressures, cyclic thermal loading, and repetitive mechanical loading on tool wear. This is difficult to achieve in conventional tribological testing devices. Therefore, the tribological behavior of tool–workpiece material pairs at elevated temperatures was studied in a newly developed experimental setup simulating the conditions prevalent during interaction of the hot sheet with the tool surface. Uncoated 22MnB5 steel and aluminum–silicon (Al–Si)-coated 22MnB5 steel were tested at 750 °C and 920 °C, respectively. It was found that higher loads led to lower and more stable friction coefficients independent of sliding velocity or surface material. The influence of sliding velocity on the coefficient of friction was only marginal. In the case of Al–Si-coated 22MnB5, the friction coefficient was generally higher and unstable due to transfer of Al–Si coating material to the tool. Adhesion was the main wear mechanism in the case of uncoated 22MnB5.