Foliar analysis is very important for the nutritional management of crops and as a supplemental parameter for soil fertilizer recommendation. The elemental composition of plants is traditionally obtained by laboratory-based methods after acid digestion of ground and sieved leaf samples. This analysis is time-consuming and generates toxic waste. By comparison, portable X-ray fluorescence (pXRF) spectrometry is a promising technology for rapid characterization of plants, eliminating such constraints. This worked aimed to assess the pXRF performance for elemental quantification of leaf samples from important Brazilian crops. For that, 614 samples from 28 plant species were collected across different regions of Brazil. Ground and sieved samples were analyzed after acid digestion (AD), followed by quantification via inductively coupled plasma optical emission spectroscopy (ICP-OES) to determine the concentration of macronutrients (P, K, Ca, Mg, and S) and micronutrients (Fe, Zn, Mn, and Cu). The same plant nutrients were directly analyzed on ground leaf samples via pXRF. Four certified reference materials (CRMs) for plants were used for quality assurance control. Except for Mg, a very strong correlation was observed between pXRF and AD for all plant-nutrients and crops. The relationship between methods was nutrient- and crop-dependent. In particular, eucalyptus displayed optimal correlations for all elements, except for Mg. Opposite to eucalyptus, sugarcane showed the worst correlations for all the evaluated elements, except for S, which had a very strong correlation coefficient. Results demonstrate that for many crops, pXRF can reasonably quantify the concentration of macro- and micronutrients on ground and sieved leaf samples. Undoubtedly, this will contribute to enhance crop management strategies concomitant with increasing food quality and food security.
Soil aggregation and carbon distribution are important indicators of soil quality. Moreover, these attributes are closely related to CO2 fluxes in the soil-atmosphere interface. We sought to evaluate soil aggregation, organic carbon distribution and CO2 evolution in different land uses of Minas Gerais Triangle. Four different land uses were selected: (1) Panicum maximum, (2) Panicum maximum Jacqvr. (Tanzânia), (3) sugarcane, and (4) native Cerrado (control). In each land-use type, soil samples from a 0-10 cm layer were collected. The samples were air-dried and sieved in order to obtain aggregates sized 4-2 mm. The samples were submitted to wet-sieving to evaluate stability and also to obtain aggregates of different sizes: 4-2 mm; 2-1 mm; 1-0.5 mm; and 0.5-0.25 mm. Total organic carbon, humic substances and texture were determined for each aggregate size fraction. The CO2 emission was measured in field and lab conditions, both by the capture in NaOH solution method. The native Cerrado and Panicum maximum Jacqvr. (Tanzânia) areas (mostly clay) showed the highest soil aggregation. The conventional soil tillage adopted in sugarcane areas contributed significantly to aggregate disruption. In all of the areas, the largest aggregates had higher organic carbon and humic substances. Organic carbon content and soil texture seem to be closely associated with CO2 emissions in the areas studied
The effects of agricultural practices on greenhouse gases emissions (e.g. CO2) at the soil-atmosphere interface have been highlighted worldwide. The use of ground limestone has been considered as the main responsible for CO2 emission from soils. However, liming is need as conditioner of acidic soils and the CO2 emission can be compensated due to carbon sequestration by plants. This study simulated under laboratory conditions the effects of two common agricultural practices in Brazil (P-fertilization and liming) on soil CO2 emission. Columns made of PVC tubes containing 1 kg of a typical Dystrophic Red Latosol from Cerrado region were incubated with CaCO3 (simulating liming), CaSiO3 (simulating slag), and different doses of KH2PO4 (simulating P-fertilization). The soil columns were moistened to reach the field capacity (0.30 cm3 cm-3) and, during 36 days, CO2 emissions at the soil surface were measured using a portable Licor LI-8100 analyzer coupled to a dynamic chamber. The results showed that CO2 emission was influenced by phosphate, carbonate, and silicate anions. When using CaSiO3, accumulated CO2 emission (36-day period) was 20% lower if compared to the use of CaCO3. The same amount of phosphate and liming (Ca-carbonate or Ca-silicate) added to the soil provided the same amount of CO2 emission. At the same P dose, as Si increased the CO2 emission increased. The highest CO2 emission was observed when the soil was amended with the highest phosphate and silicate doses. Based on this experiment, we could oppose the claim that the use of limestone is a major villain for CO2 emission. Also, we have shown that other practices, such as fertilization using P + CaSiO3, contributed to a higher CO2 emission. Indeed, it is important to emphasize that the best practices of soil fertility management will undoubtedly contribute to the growth of crops and carbon sequestration.
Assessing pedotransfer functions to estimate the soil water retention = Validação de funções de pedotransferência para estimativa da retenção de água no solo