The micromorphological changes and the strength formation mechanism of the curing of epoxy asphalt, which is mostly used for steel bridge deck pavements, were investigated. A tensile test was used to analyze the mechanical properties of epoxy asphalt, and Fourier transform infrared spectroscopy (FTIR) was used to determine the change in the epoxy peak area. Laser scanning confocal microscopy (LSCM) and scanning electron microscopy (SEM) were used to observe two-dimensional and three-dimensional micromorphological changes, respectively, during the curing reaction of epoxy asphalt. The results of the tensile and FTIR tests on epoxy asphalt showed that the tensile strength and epoxy conversion rate both increased with the curing time and exhibited similar trends, indicating that the network formed by the crosslinking and polymerization of epoxy groups causes the increased strength of epoxy asphalt. The curing degree of epoxy asphalt during the curing reaction can be indirectly evaluated from the conversion rate of epoxy groups. The asphalt tended to evenly be dispersed in the continuous phase of the epoxy resin during the formation of the epoxy resin network, and the network structure increased the deformation of the epoxy resin. The epoxy asphalt curing reaction process was classified into three stages based on the degree of curing.

Recycled asphalt mixtures (RAM), which are prepared by blending reclaimed asphalt pavement (RAP), virgin bitumen and mineral additives, provide a variety of advantages, including resource recycling, reductions in costs, and reduced negative environmental impacts. However, multiple agencies have expressed concerns about the utilization ratio of RAP; thus, a comprehensive understanding of the blending degree of virgin and RAP binders in RAM would be significantly helpful for promoting the application of RAP. This study aims to quantitatively analyze the blending degree of virgin and RAP binders in RAM with high RAP contents. Carboxyl-terminated butadiene acrylonitrile (CTBN) was utilized as a tracer to mark the virgin bitumen; in addition, Fourier transform infrared (FTIR) spectroscopy was used to develop the structural index of CTBN (I_CTBN). By establishing the standard curve between I_CTBN and the CTBN content, the blending degree of virgin and RAP binders at different locations within RAM can be determined quantitatively. The study results indicate that the RAP binder was completely blended with the virgin bitumen in the outer RAP layer. However, the blending degree decreased with an increase in the RAP depth, and the blending degree in the inner RAP layer was only approximately half that which was found in the case of complete blending.