Ali mohsenatabar firozjaii

Mr. Ali mohsenatabar firozjaii


Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 July 2019 in Journal of Petroleum Exploration and Production Technology
Verified
Journal Article
Open access
PDF file
OHOmid Mosalman Haghighi
Omid Mosalman Haghighi
AFAli mohsenatabar firozjaii
Ali mohsenatabar firozjaii
Enhancing oil recovery from oil-wet carbonate oil reservoir is an important challenge in the world, especially in Middle East oil field. Surfactant and smart water can change the interfacial tension and wettability condition of this type of rock to water wet from oil wet. The present study follows the experimental work of the combination of new green surfactant with smart water to enhance oil recovery from a carbonate oil-wet rock. Wettability alternation and IFT reduction by surfactant, smart water and combination of surfactant with smart water were investigated experimentally. The results show that making surfactant solution using smart water can reduce oil saturation by reducing IFT and alter wettability conditions. The oil recovery factor at the end of water, surfactant and surfactant–smart water flooding was 36, 52 and 66%, respectively. It shows that combination of surfactant with smart water can help surfactant to be powerful.

12 October 2018 in Journal of Petroleum Exploration and Production Technology
Verified
Journal Article
Open access
PDF file
AFAli mohsenatabar firozjaii
Ali mohsenatabar firozjaii
GZGhassem Zargar
Ghassem Zargar
EKEzatallah Kazemzadeh
Ezatallah Kazemzadeh
In this study, the new type of polymer was considered for rheological study and core flooding test in high temperature and high salinity (HTHS) condition. This polymer is called co-polymer Zetag 8187G which is used as flocculant in water industry. By studding the rheological properties of this polymer compared to one of the commercial polymer for HTHS condition, Zetag 8187G was considered for polymer flooding in sandstone core at 185 °F and 150,000 ppm of salinity in present of divalent ions (Ca2+, Mg2+) in experimental and simulation cases due to better stability compared to other. The core flooding results showed this co-polymer swept the oil toward low residual oil saturation in porous media. In addition, the core flooding results showed that was not occurred significant damage in rock during polymer flooding using Zetag 8187G. More than, in the simulation case, the change of relative permeability curve during water and polymer flooding was obtained using history matching of production data. The experimental and simulation results show this polymer can applicable in oil industry as well as application in water industry.

27 August 2018 in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
Verified
Journal Article
Closed access
AFAli mohsenatabar firozjaii
Ali mohsenatabar firozjaii
ADAmin Derakhshan
Amin Derakhshan
SSSeyed Reza Shadizadeh
Seyed Reza Shadizadeh
The main aim of the present work was to study history matching of surfactant flooding using CMG-STARS simulator and experimental results. In the experimental case, the critical micellar concentration of dodecyltrimethylammonium bromide solution is obtained, and the changes in the contact angle are investigated from 1 to 10% weight. Then, after water flooding, surfactant flooding is applied on the critical micellar concentration of dodecyltrimethylammonium bromide. In the simulation case, after history matching of production data, the performance of alkaline-surfactant-polymer flooding using sodium hydroxide, hydrolyzed polyacrylamide, and that surfactant was a prediction. The numerical simulation alkaline-surfactant-polymer flooding increased the oil recovery factor 26% more than surfactant flooding.

28 November 2018 in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
Verified
Journal Article
Closed access
AFAli mohsenatabar firozjaii
Ali mohsenatabar firozjaii
MAMajid Akbari
Majid Akbari
GZGhassem Zargar
Ghassem Zargar
Several factors effect on choosing the best enhanced oil recovery process in a hydrocarbon reservoir. In the present study, effective factors on chemical enhanced oil recovery involved in polymer flooding, surfactant flooding, surfactant–polymer flooding, and alkaline–surfactant–polymer flooding are discussed in numerical simulation. The numbers of the simulation runs are estimated based on the number of factors and their maximum and minimum values using experimental design software. Oil recovery factor from reservoir simulation is considered as comparison factor in all of the run cases. The results from one parameter and two interaction factors during each flooding case were analyzed by Tornado and Parto plot. The oil recovery factor also was estimated using statistical analysis using Minitab. The results show that there is a strong correlation between simulation and statistical analysis. Furthermore, the results show that each selected factor has a different effect on oil recovery in each case of chemical flooding. The case study results on two Iranian oil fields at the end of the present study clarified that results of this study can be useful for selecting the best chemical process for oil reservoir based on reservoir properties.

1 October 2019 in Energy Sources, Part A: Recovery, Utilization, and Environmental Effects
Verified
Journal Article
Closed access
AJAli Jalali
Ali Jalali
AFAli mohsenatabar firozjaii
Ali mohsenatabar firozjaii
SSSeyed Reza Shadizadeh
Seyed Reza Shadizadeh
It is necessary to enhance oil production from reservoir due to increase of the fossil fuel consumption that results of industrial life development. Surfactant flooding is a popular method to enhance oil recovery by IFT reduction and wettability alteration. In this study, a new natural surfactant that extracted from Cordia myxa leaf is used for surfactant flooding. The effect of this natural surfactant on IFT and wettability is investigated experimentally. Then, surfactant flooding is applied in a carbonate core sample. The results show the IFT of solution was reduced from 33/28mN/M at 0 wt% to 16.24 mN/M at 6 wt% by increasing natural surfactant concentration. More than, contact angle was decreased from 137.05° at 0 wt. % to 130.65° at 5.5 wt. %. The core flooding results show C. myxa flooding increased 27% more oil recovery compared to water flooding and reduced residual oil saturation in porous media. The results show C. myxa can be applicable as a green surfactant for enhancing oil recovery.