sun chao

Dr. sun chao

orcid

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
13 April 2020 in Crystals
Verified
Journal Article
Open access
PDF file
SCsun chao
sun chao
NLNannan Lu
Nannan Lu
HLHuan Liu
Huan Liu
Xiaojun WangXiaojun Wang
Xiaojun Wang
XHX. S. Hu
X. S. Hu
DCDeqiang Chen
Deqiang Chen
In this study, the dry sliding wear behaviors of SiC particle reinforced AZ91D matrix composites fabricated by stirring casting method were systematically investigated. The SiC particles in as-cast composites exhibited typical necklace-type distribution, which caused the weak interface bonding between SiC particles and matrix in particle-segregated zones. During dry sliding at higher applied loads, SiC particles were easy to debond from the matrix, which accelerated the wear rates of the composites. While at the lower load of 10 N, the presence of SiC particles improved the wear resistance. Moreover, the necklace-type distribution became more evident with the decrease of particle sizes and the increase of SiC volume fractions. Larger particles had better interface bonding with the matrix, which could delay the transition of wear mechanism from oxidation to delamination. Therefore, composites reinforced by larger SiC particles exhibited higher wear resistance. Similarly, owing to more weak interfaces in the composites with high content of SiC particles, more severe delamination occurred and the wear resistance of the composites was impaired.

Verified
Journal Article
Open access
PDF file
WTWenchen Teng
Wenchen Teng
ZWZhuoyi Wang
Zhuoyi Wang
ZXZiyue Xu
Ziyue Xu
JXJie Xin
Jie Xin
SCsun chao
sun chao
Jing BaiJing Bai
Jing Bai
Magnesium (Mg) reinforced polylactic acid (PLA) composites have attracted increasing interest for orthopedic implants to solve the insufficient strength of PLA and to utilize the bioactive advantages of Mg ions in promoting bone formation. However, the weak interfacial adhesion between the Mg and PLA limits the applications of the composite. In this study, a dual interfacial enhancement approach was designed to combine surface fluorination with perforation. During hot pressing, molten PLA infiltrates the pores to form a ‘rivet-like’ mechanical interlocking. This structure significantly alters the load transfer and degradation behaviors of the composite. Compared to pure PLA, the dual treatment significantly elevated the bending strength by 49%, alongside an increase in the bending strain from 15% to 25%. Moreover, in vitro degradation tests revealed that this strategy suppresses H2-induced delamination, and stabilizes both pH and Mg2+ release. Consequently, the bending strength remained at 86% after six weeks of in vitro degradation. In addition, the composite exhibits excellent biocompatibility, with MC3T3-E1 cell viability exceeding 90% in 100% extract. These results demonstrate that the reinforced Mg/PLA composite exhibits excellent mechanical properties, degradation stability, and biocompatibility, showing high potential for load-bearing orthopedic fixation applications.

13 July 2026 in Corrosion Science
Verified
Journal Article
Closed access
SCsun chao
sun chao
ZXZiyue Xu
Ziyue Xu
QQQian Qiu
Qian Qiu
MYMing Yin
Ming Yin
CWCheng Wang
Cheng Wang
Jing BaiJing Bai
Jing Bai

1 May 2026 in Journal of Magnesium and Alloys
Verified
Journal Article
Open access
ZXZiyue Xu
Ziyue Xu
HLHuan Liu
Huan Liu
SCsun chao
sun chao
LLLuyao Li
Luyao Li
YWYuna Wu
Yuna Wu
JMJiang Ma
Jiang Ma

29 September 2026 in Surfaces and Interfaces
Verified
Journal Article
Closed access
MYMengmeng Yang
Mengmeng Yang
XCXueqi Chen
Xueqi Chen
XCXiang Cai
Xiang Cai
DMDun Miao
Dun Miao
SCsun chao
sun chao
Jing BaiJing Bai
Jing Bai

21 September 2026 in Molecules
Verified
Journal Article
Open access
PDF file
CWCheng Wang
Cheng Wang
MYMing Yin
Ming Yin
ZYZiwei Yuan
Ziwei Yuan
TZTingting Zhang
Tingting Zhang
ZXZiyue Xu
Ziyue Xu
Jing BaiJing Bai
Jing Bai
Understanding the dynamic interfacial microenvironment of degrading Mg alloys is critical for elucidating the evolution of localized corrosion under physiological conditions. Here, spatially resolved microsensors were used to characterize the local pH and H2 concentration at the interfaces of Mg-Y-Al-Zn alloys without Gd (0Gd) and with 3 wt.% Gd (3Gd) during degradation in Hanks’ balanced salt solution (HBSS). Both local pH and H2 concentration rapidly increased at the interfaces of 0Gd and 3Gd immediately after immersion in HBSS, accompanied by pronounced near-surface pH and H2 gradients. The initial local pH and H2 level for 0Gd were comparable to or slightly lower than those of 3Gd. However, 0Gd subsequently exhibited distinct localized high pH and H2 level associated with the filiform corrosion. From 3 to 12 h, the localized pH and H2 features of 0Gd progressively intensified, while 3Gd maintained a relatively weaker and more spatially distributed response. During prolonged immersion from 16 to 18 h, localized H2 accumulation also emerged on 3Gd despite comparatively moderate local alkalization. These findings reveal the dynamic and spatially heterogeneous nature of the Mg corrosion microenvironment and demonstrate that simultaneous mapping of local pH and H2 provides complementary information for resolving its spatiotemporal evolution.