Yunus Can Gültekin

Mr. Yunus Can Gültekin

orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 September 2019 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
AAAbdelkerim Amari
Abdelkerim Amari
SGSebastiaan Goossens
Sebastiaan Goossens
YGYunus Can Gültekin
Yunus Can Gültekin
OVOlga Vassilieva
Olga Vassilieva
IKInwoong Kim
Inwoong Kim
AAAlex Alvarado
Alex Alvarado
Probabilistic shaping based on constant composition distribution matching (CCDM) has received considerable attention as a way to increase the capacity of fiber optical communication systems. CCDM suffers from significant rate loss at short blocklengths and requires long blocklengths to achieve high shaping gain, which makes its implementation very challenging. In this paper, we propose to use enumerative sphere shaping (ESS) and investigate its performance for the nonlinear fiber optical channel. ESS has lower rate loss than CCDM at the same shaping rate, which makes it a suitable candidate to be implemented in real-time high-speed optical systems. In this paper, we first show that finite blocklength ESS and CCDM exhibit higher effective signal-to-noise ratio than their infinite blocklength counterparts. These results show that for the nonlinear fiber optical channel, large blocklengths should be avoided. We then show that for a 400 Gb/s dual-polarization 64-QAM WDM transmission system, ESS with short blocklengths outperforms both uniform signaling and CCDM. Gains in terms of both bit-metric decoding rate and bit-error rate are presented. ESS with a blocklength of 200 is shown to provide an extension reach of about 200 km in comparison with CCDM with the same blocklength. The obtained reach increase of ESS with a blocklength of 200 over uniform signaling is approximately 450 km (approximately 19%).

11 November 2019 in IEEE Transactions on Wireless Communications
Verified
Journal Article
Open access
YGYunus Can Gültekin
Yunus Can Gültekin
WHWim J. van Houtum
Wim J. van Houtum
AKArie G. C. Koppelaar
Arie G. C. Koppelaar
FWFrans M. J. Willems
Frans M. J. Willems
Probabilistic amplitude shaping (PAS) combines an outer shaping layer with an inner, systematic forward error correction (FEC) layer to close the shaping gap. Proposed for PAS, constant composition distribution matching (CCDM) produces amplitude sequences with a fixed empirical distribution. We show that CCDM suffers from high rate losses for small block lengths, and we propose to use Enumerative Sphere Shaping (ESS) instead. ESS minimizes the rate loss at any block length. Furthermore, we discuss the computational complexity of ESS and demonstrate that it is significantly smaller than shell mapping (SM), which is another method to perform sphere shaping. We then study the choice of design parameters for PAS. Following Wachsmann et al., we show that for a given constellation and target rate, there is an optimum balance between the FEC code rate and the entropy of the Maxwell-Boltzmann distribution that minimizes the gap-to-capacity. Moreover, we demonstrate how to utilize the non-systematic convolutional code from IEEE 802.11 in PAS. Simulations over the additive white Gaussian noise (AWGN) and frequency-selective channels exhibit that ESS is up to 1.6 and 0.7 dB more energy-efficient than uniform signaling at block lengths as small as 96 symbols, respectively, with convolutional and low-density parity-check (LDPC) codes.

21 May 2020 in Entropy
Verified
Journal Article
Open access
PDF file
YGYunus Can Gültekin
Yunus Can Gültekin
TFTobias Fehenberger
Tobias Fehenberger
AAAlex Alvarado
Alex Alvarado
FWFrans M. J. Willems
Frans M. J. Willems
In this paper, we provide a systematic comparison of distribution matching (DM) and sphere shaping (SpSh) algorithms for short blocklength probabilistic amplitude shaping. For asymptotically large blocklengths, constant composition distribution matching (CCDM) is known to generate the target capacity-achieving distribution. However, as the blocklength decreases, the resulting rate loss diminishes the efficiency of CCDM. We claim that for such short blocklengths over the additive white Gaussian noise (AWGN) channel, the objective of shaping should be reformulated as obtaining the most energy-efficient signal space for a given rate (rather than matching distributions). In light of this interpretation, multiset-partition DM (MPDM) and SpSh are reviewed as energy-efficient shaping techniques. Numerical results show that both have smaller rate losses than CCDM. SpSh—whose sole objective is to maximize the energy efficiency—is shown to have the minimum rate loss amongst all, which is particularly apparent for ultra short blocklengths. We provide simulation results of the end-to-end decoding performance showing that up to 1 dB improvement in power efficiency over uniform signaling can be obtained with MPDM and SpSh at blocklengths around 200. Finally, we present a discussion on the complexity of these algorithms from the perspectives of latency, storage and computations.

19 October 2021 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
YGYunus Can Gültekin
Yunus Can Gültekin
AAAlex Alvarado
Alex Alvarado
OVOlga Vassilieva
Olga Vassilieva
IKInwoong Kim
Inwoong Kim
PPPaparao Palacharla
Paparao Palacharla
FWFrans M. J. Willems
Frans M. J. Willems
Nonlinear interference (NLI) generated during the propagation of an optical waveform through the fiber depends on the fourth order standardized moment of the channel input distribution, also known as kurtosis. Probabilistically-shaped inputs optimized for the linear Gaussian channel have a Gaussian-like distribution with high kurtosis. For optical channels, this leads to an increase in NLI power and consequently, a decrease in effective signal-to-noise ratio (SNR). In this work, we propose kurtosis-limited enumerative sphere shaping (K-ESS) as an algorithm to generate low-kurtosis shaped inputs. Numerical simulations at a shaping blocklength of 108 amplitudes demonstrate that with K-ESS, it is possible to increase the effective SNRs by 0.4 dB in a single-span single-channel scenario at 400 Gbit/s. K-ESS offers also a twofold decrease in frame error rate with respect to Gaussian-channel-optimal sphere shaping.

8 November 2021 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
KWKaiquan Wu
Kaiquan Wu
GLGabriele Liga
Gabriele Liga
ASAlireza Sheikh
Alireza Sheikh
YGYunus Can Gültekin
Yunus Can Gültekin
FWFrans M. J. Willems
Frans M. J. Willems
AAAlex Alvarado
Alex Alvarado
Recently, a metric called energy dispersion index (EDI) was proposed to qualitatively indicate the nonlinear interference (NLI) induced by correlated symbols during optical transmission. In this paper, we propose a new shaper architecture to decrease the EDI of transmitted symbols and thus, increase the signal-to-noise ratio (SNR). We call this shaper the list-encoding constant-composition distribution matcher (L-CCDM). L-CCDM consists of an additional EDI selecting module, which is compatible with standard probabilistic amplitude shaping (PAS) architecture. Numerical results obtained from a multi-span multi-channel system show that when compared to standard CCDM with 256-ary quadrature amplitude modulation (256QAM), the proposed architecture offers an effective SNR gain of 0.35 dB, an achievable information rate gain of 0.22 b/4D-symbol, or equivalently an 8% reach extension.

8 November 2022 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
SGSebastiaan Goossens
Sebastiaan Goossens
YGYunus Can Gültekin
Yunus Can Gültekin
OVOlga Vassilieva
Olga Vassilieva
IKInwoong Kim
Inwoong Kim
PPPaparao Palacharla
Paparao Palacharla
AAAlex Alvarado
Alex Alvarado
Four dimensional geometric shell shaping (4D-GSS) is introduced as an approach for closing the nonlinearity-caused shaping gap. This format is designed at the spectral efficiency of 8 b/4D-sym and is compared against polarization-multiplexed 16QAM (PM-16QAM) and probabilistically shaped PM-16QAM (PS-PM-16QAM) in a 400ZR-compatible transmission setup with high amount of nonlinearities. Reach increase and nonlinearity tolerance are evaluated in terms of achievable information rates and post-FEC bit-error rate. Numerical simulations for a single-span, single-channel show that 4D-GSS achieves increased nonlinear tolerance and reach increase against PM-16QAM and PS-PM-16QAM when optimized for bit-metric decoding ( $\mathrm{R}_\mathrm{BMD}$ ). In terms of $\mathrm{R}_\mathrm{BMD}$ , gains are small with a reach increase of 1.7% compared to PM-16QAM. When optimizing for mutual information, a larger reach increase of 3% is achieved compared to PM-16QAM. Moreover, the introduced GSS scheme provides a scalable framework for designing well-structured 4D modulation formats with low complexity.