This paper gives a basic review and a summary of recent developments for leaky-wave antennas (LWAs). An LWA uses a guiding structure that supports wave propagation along the length of the structure, with the wave radiating or “leaking” continuously along the structure. Such antennas may be uniform, quasi-uniform, or periodic. After reviewing the basic physics and operating principles, a summary of some recent advances for these types of structures is given. Recent advances include structures that can scan to endfire, structures that can scan through broadside, structures that are conformal to surfaces, and structures that incorporate power recycling or include active elements. Some of these novel structures are inspired by recent advances in the metamaterials area.

Resonance conditions for a substrate-superstrate printed antenna geometry which allow for large antenna gain are presented. Asymptotic formulas for gain, beamwidth, and bandwidth are given, and the bandwidth limitation of the method is discussed. The method is extended to produce narrow patterns about the horizon, and directive patterns at two different angles.

A novel slotted substrate integrated waveguide (SIW) leaky-wave antenna is proposed. This antenna works in the TE₁₀ mode of the SIW. Leakage is obtained by introducing a periodic set of transverse slots on the top of the SIW, which interrupt the current flow on the top wall. It is seen that three modes (a leaky mode, a proper waveguide mode, and a surface-wave-like mode) can all propagate on this structure. The wavenumbers of the modes are calculated theoretically and are numerically evaluated by HFSS simulation. The leakage loss, dielectric loss, and conductor loss are also analyzed. A uniform slotted SIW leaky-wave antenna is designed that has good beam scanning from near broadside (though not exactly at broadside) to forward endfire. This type of SIW leaky-wave antenna has a wide impedance bandwidth and a narrow beam that scans with frequency. Measured results are consistent with the simulation and the theoretical analysis.

The fundamental effects of superstrate (cover) materials on printed circuits antennas are investigated. Substrate-superstrate resonance conditions are established which maximize antenna gain, radiation resistance, and radiation efficiency. Criteria are determined for material properties and dimensions for which surface waves are eliminated and a radiation efficiency due to substrate-superstrate effects ofe_{s} = 100percent is obtained. Criteria for nearly omnidirectional\bar{H}-plane patterns and nearly omnidirctional\bar{E}-plane patterns are presented. Finally, a general criterion is given for choosing a superstrate to optimize efficiency for the important case of nonmagnetic layers with the antenna at the interface.