Liquid fibrinogen is an injectable platelet concentrate rich in platelets, leukocytes, and fibrinogen obtained by blood centrifugation. The aim of this study was to analyze the release of different growth factors in the liquid fibrinogen at different times and to assess possible correlations between growth factors and cell counts. The concentration of transforming growth factor beta 1 (TGF-β1), platelet-derived growth factor-AB (PDGF-AB), platelet-derived growth factor-BB (PDGF-BB), bone morphogenetic protein 2 (BMP-2), fibroblast growth factor 2 (FGF-2) and vascular endothelial growth factor (VEGF) released by liquid fibrinogen were examined with ELISA at three time points (T0, time of collection; T7, 7 days; T14, 14 days). The cellular content of the liquid fibrinogen and whole blood was also calculated for each volunteer. A mean accumulation of platelets of almost 1.5-fold in liquid fibrinogen compared to whole blood samples was found. An increase of TGF-β1, PDGF-AB, FGF-2, and VEGF levels was detected at T7. At T14, the level of TGF-β1 returned to T0 level; PDGF-AB amount remained high; the levels of FGF-2 and VEGF decreased with respect to T7, but remained higher than the T0 levels; PDGF-BB was high at all time points; BMP-2 level was low and remained constant at all time points. TGF-β1, PDGF-AB, and PDGF-BB showed a correlation with platelet amount, whereas BMP-2, FGF-2, and VEGF showed a mild correlation with platelet amount. Due to the high concentration of platelets, liquid fibrinogen does contain important growth factors for the regeneration of both soft and hard tissue. The centrifugation protocol tested in this study provides a valid solution to stimulate wound healing in oral and periodontal surgery.

The surgical treatment of peri-implantitis is currently based on the removal of biofilms from the implant surface by primary means of mechanical and physical treatments. However, such approaches often determine some alterations of the implant surface with detrimental effects on re-osseointegration. This study aims to evaluate the effects of four different mechanical and physical treatments on titanium samples with moderately rough surface. Air powder abrasion (AP) with glycine powder, a titanium brush (TB) and a diode laser at 3 W (L3) and 4 W (L4) were tested. Surface morphology, roughness and chemical composition were then assessed by scanning electron microscope (SEM), white light interferometer and X-ray photoelectron spectroscopy (XPS), respectively. The microscopic analysis revealed significant alterations in surface morphology on TB samples, while AP and L3 had only a minor or null impact. L4 samples revealed signs of overheating due to the excessive power. Nevertheless, the overall roughness of the samples was not significantly altered in terms of roughness parameters. Similarly, surface chemical composition was not significantly affected by the treatments. Among the treatments tested in this study, air powder abrasion with glycine powder and 3 W diode laser had the lowest impact on surface physicochemical properties.