This study aims at introducing the back stress of anisotropic strain-hardening into the crystal plasticity theory and demonstrating the rationality of this crystal plasticity model to describe the evolution of the subsequent yield surface of polycrystalline aluminum at the mesoscopic scale under complex pre-cyclic loading paths. By using two different scale finite element models, namely a global finite element model (GFEM) as the same size of the thin-walled tube specimen used in the experiments and a 3D cubic polycrystalline aggregate representative volume element (RVE) model, the evolution of the subsequent yield surface for different unloading cases after 30 pre-cycles is further performed by experiments and numerical simulations within a crystal plasticity finite element (CPFE) frame. Results show that the size and shape of the subsequent yield surfaces are extremely sensitive to the chosen offset strain and the pre-cyclic loading direction, which present pronounced anisotropic hardening through a translation and a distortion of the yield surface characterized by the obvious “sharp corner” in the pre-deformation direction and “flat” in the reverse direction by the definition of small offset strain, while the subsequent yield surface exhibits isotropic hardening reflected by the von Mises circle to be distorted into an ellipse by the definition of large offset strain. In addition, the heterogeneous properties of equivalent plastic strain increment are further discussed under different offset strain conditions. Modeling results from this study show that the heterogeneity of plastic deformation decreases as a law of fraction exponential function with the increasing offset strain. The above analysis indicates that anisotropic hardening of the yield surface is correlated with heterogeneous deformation caused by crystal microstructure and crystal slip. The crystal plasticity model based on the above microscopic mechanism can accurately capture the directional hardening features of the yield surface.
To reveal the relationship between grain size and twinning deformation of magnesium alloys under cyclic strain, this study carried out a group of strain-controlled low-cycle fatigue experiments and statistical analysis of microstructures. Experimental results show that the shape of the hysteresis loop exhibits significant asymmetry at different strain amplitudes, and the accumulation of residual twins plays an important role in subsequent cyclic deformation. For the different strain amplitudes, the statistical distribution of the grain size of magnesium alloy approximately follows the Weibull probability function distribution, while the statistical distribution of twin thickness is closer to that of Gaussian probability function. The twin nucleation number (TNN) increases with the increase of grain size, but there is no obvious function relationship between twin thickness and grain size. Twin volume fraction (TVF) increases with the increase of grain size, which is mainly due to the increase of TNN. This work can provide experimental evidence for a more accurate description of the twinning deformation mechanism.
To study the influencing factors of process parameters on the wall thickness deviation and internal warpage deviation of the workpiece in magnesium alloy wheel hub spin molding, a two-pass heterogeneous spin molding model is proposed. To ensure the accuracy of the simulation results, the stress–strain data of AZ31 magnesium alloy at different temperatures and different strain rates were obtained through tests. Wall thickness deviation and internal warp deviation after molding were used as evaluation indexes of workpiece molding quality. ABAQUS software facilitated the numerical simulation and analysis of the magnesium alloy wheel hub spinning process. Gray relational degree analysis optimized the first-pass process parameters, elucidating the impact of the axial offset, the thinning ratio, and the feed ratio on forming quality. The application of optimized parameters in the hub spinning simulation resulted in a substantial 28.84% reduction in wall thickness deviation and a 4.88% reduction in inner diameter deviation. This study underscores the efficacy of employing Gray Relational Analysis for comprehensive parameter optimization, ensuring wheel hub quality. Moreover, it provides a theoretical foundation for enterprises to expedite research and development cycles and minimize associated costs.