Due to increased carbon emissions, the use of low-carbon and low-cost cementitious materials that are sustainable and effective are gaining considerable attention recently for the stabilization/solidification (S/S) of contaminated soils. The current study presents the laboratory investigation of low-carbon/cost cementitious material known as limestone-calcined clay cement (LC3) for the potential S/S of Zn- and Pb-contaminated soils. The S/S performance of the LC3 binder on Zn- and Pb-contaminated soil was determined via pH, compressive strength, toxicity leaching, chemical speciation, and X-ray powder diffraction (XRPD) analyses. The results indicate that immobilization efficiency of Zn and Pb was solely dependent on the pH of the soil. In fact, with the increase in the pH values after 14 days, the compressive strength was increased to 2.5–3 times compared to untreated soil. The S/S efficiency was approximately 88% and 99%, with increase in the residual phases up to 67% and 58% for Zn and Pb, respectively, after 28 days of curing. The increase in the immobilization efficiency and strength was supported by the XRPD analysis in forming insoluble metals hydroxides such as zincwoodwardite, shannonite, portlandite, haturite, anorthite, ettringite (Aft), and calcite. Therefore, LC3 was shown to offer green and sustainable remediation of Zn- and Pb-contaminated soils, while the treated soil can also be used as safe and environmentally friendly construction material.
18 September 2021 in Environmental Science and Pollution Research
The low-carbon and low-cost cement known as limestone–calcined clay cement (LC3) is used in this study to investigate the immobilization potential of Pb-Zn smelter residue (LZSR). The performance of LC3 treatment on LZSR was determined through a series of experiments, including pH, unconfined compressive strength (UCS), toxicity characteristic leaching procedure (TCLP), Community Bureau of Reference sequential extraction procedure (BCR-SEP), Fourier-transform infrared spectroscopy (FTIR), thermogravimetric analysis (TGA), X-ray diffraction (XRD), and scanning electron microscopy along with energy dispersive spectroscopy (SEM-EDS). The findings show that, after 14 days curing, the transition in the pH from acid to alkaline increases the UCS up to 2.5–3.6 times compared with untreated specimens. The leached concentrations of Pb, Zn, and Cd decreased considerably with increasing binder and curing time. Chemical speciation analysis showed that >50% of bioavailable phases (acid-soluble and reducible phases) were transformed into less soluble (oxidizable and residual) phases. The XRD and SEM-EDS analysis demonstrated that the formation of favorably insoluble alite (Ca3SiO5), meionite (Ca4Al6Si6O24CO3), and portlandite (Ca(OH)2) was responsible for the immobilization of Pb, Zn, and Cd. As a result, LC3 supports the green and sustainable remediation approach for the immobilization of heavy metals for the potential valorization of LZSR.