Interstory drift measurement is a critical parameter for determining earthquake damages in civil engineering structures. It can be measured using global positioning systems (GPS), accelerometers, LVDTs, and so forth. Each of these methods has limitations in terms of accuracy, cost, installation, and so on. In this study, a novel, laser-based in situ interstory drift measurement setup is proposed and tested on a shake table on which the laser sensors were mounted in the frame to measure interstory drift without any reference frame. The in situ measurements are compared with measurements from reference lasers, which are mounted on a frame separate from the structure.

The magnetorheological fluids (MRF) are a generation of smart fluids with the ability to alter their variable viscosity. Moreover, the state of the MRF can be switched from the semisolid to the fluid phase and vice versa upon applying or removing the magnetic field. The fast response and the controllability are the main features of the MRF-based systems, which make them suitable for applications with high sensitivity and controllability requirements. Nowadays, MRF-based systems are rapidly growing and widely being used in many industries such as civil, aerospace, and automotive. This study presents a comprehensive review to investigate the fundamentals of MRF and manufacturing and applications of MRF-based systems. According to the existing works and current and future demands for MRF-based systems, the trend for future research in this field is recommended.

Rapid growth in generating power from wind turbines led to application of long laminated composite blades. However, as the length of blades increases, the risk of failure due to excessive vibration increases. Therefore, a reliable wind power generator requires an efficient and accurate, yet economical structural health monitoring system to detect vibration and apply a reliable control to prevent from unpredicted failure. This paper presents an optimal, low cost and continuous vibration monitoring system for laminated composite blades using Fiber Bragg Grating (FBG). Utilizing a layerwise displacement theory, the Finite Element (FEM) model has been developed for the wind turbine blade. The optomechanical relations between strains and FBG wavelength shift have been presented to study the dynamic of a wind turbine blade. The reflected spectrum caused by modal displacement, interrogated by WDM method has been studied for vibration control. Numerical examples have been presented to compare the FEM and FBG results which show a very good agreement for the first 3 vibration modes.

In the present work, an unsymmetric laminated plate with surface bonded piezoelectric sensors, and actuators has been considered. Piezoelectric sensor were used to monitor the load and deformation bifurcation occurs. Monitoring the shape and load of a morphing structure is essential to ascertain that the structure is properly deployed and it is not loaded excessively ,thus, preventing structural to failure. A piezoceramic actuator is used to provide activation load and to force the structure to change its stability state from one to another. A non-linear finite element model based on the layerwise displacement theory considering the electro-mechanical coupling effects of piezoelectric elements has been developed for simulation purposes. A control mechanism is also employed to actively control the shape of the structure. It is observed that, utilizing multistable composite to design a morphing structure may significantly reduce the energy required for changing the shape. Further controlling the buckling phenomena using piezoelectric sensor and actuator along with an ON/OFF controller can effectively and efficiency enhance the performance of the morphing structure during manoeuver.