Nanoporous and single phase α-alumina membranes with pore diameters tunable over a wide range of approximately 60–350 nm were successfully fabricated by optimizing the conditions for anodizing, subsequent detachment, and heat treatment. The pore diameter increased and the cell diameter shrunk upon crystallization to α-alumina by approximately 20% and 3%, respectively, in accordance with the 23% volume shrinkage resulting from the change in density associated with the transformation from the amorphous state to α-alumina. Nevertheless, flat α-alumina membranes, each with a diameter of 25 mm and a thickness of 50 μm, were obtained without thermal deformation. The α-alumina membranes exhibited high chemical resistance in various concentrated acidic and alkaline solutions as well as when exposed to high temperature steam under pressure. The Young’s modulus and hardness of the single phase α-alumina membranes formed by heat treatment at 1250 °C were notably decreased compared to the corresponding amorphous membranes, presumably because of the nodular crystallite structure of the cell walls and the substantial increase in porosity. Furthermore, when used for filtration, the α-alumina membrane exhibited a level of flux higher than that of the commercial ceramic membrane.
Inspired by a bacteriogenic, iron-based oxide material and a traditional Japanese red pigment, a bright yellowish-red pigment was prepared by heating an Al-containing iron oxyhydroxide precursor. The obtained red pigment had a unique porous disk-like structure, comprising Al-substituted hematite particles and crystalline alumina nanoparticles. Although these disk-like structures loosely gathered to form an aggregate in powder, they can be easily dispersed into a single, disk-like structure by simple ultrasonic irradiation. The powder exhibited a bright yellowish-red color and high thermostability, making it attractive as a coloring material for various industrial products needing a bright-red color, high weather resistance, and durability. Quantitative color measurements revealed extremely high L*, a*, and b* values that are much greater than those of commercially available hematite. The thermostability test showed that even after exposure to high temperatures, the pigment retained the red color, indicating its high thermostability. The unique microstructure should be strongly related to the bright yellowish-red color and the high thermostability of the developed red pigment.
3 January 2020 in Journal of the Electrochemical Society
Focusing on the coulombic efficiency of film formation, we systematically investigated the effects of polyhydric alcohols added to a sulfuric-acid-based electrolyte on the anodization behavior of aluminum, the coating ratio, the porosity, and the maximum attainable film thickness of the anodic oxide film by comparison with the effects of monohydric alcohols. Anodization was conducted in sulfuric acid containing various alcohols with different physical properties at a constant current density of 100 A·m−2 and at 20 °C. The viscosity and conductivity of the mixed electrolyte were affected by the addition of alcohol, resulting in an increase of the steady-state voltage with increasing alcohol concentration because of the high viscosity and low conductivity of the mixed electrolyte. Although the coating ratio, which is an index value used to evaluate the efficiency of the film formation, and the maximum attainable film thickness also increased with the addition of any of the alcohols, the addition of a polyhydric alcohol was more effective than that of a monohydric alcohol. When sulfuric acid with 50 vol% ethylene glycol was used as an electrolyte, an alumina film with less than 10% porosity was formed with high coulombic efficiency of film formation.