The notable increase in biofuel usage by the road transportation sector in Brazil during recent years has significantly altered the vehicular fuel composition. Consequently, many uncertainties are currently found in particulate matter vehicular emission profiles. In an effort to better characterise the emitted particulate matter, measurements of aerosol physical and chemical properties were undertaken inside two tunnels located in the São Paulo Metropolitan Area (SPMA). The tunnels show very distinct fleet profiles: in the Jânio Quadros (JQ) tunnel, the vast majority of the circulating fleet are light duty vehicles (LDVs), fuelled on average with the same amount of ethanol as gasoline. In the Rodoanel (RA) tunnel, the particulate emission is dominated by heavy duty vehicles (HDVs) fuelled with diesel (5% biodiesel). In the JQ tunnel, PM2.5 concentration was on average 52 μg m−3, with the largest contribution of organic mass (OM, 42%), followed by elemental carbon (EC, 17%) and crustal elements (13%). Sulphate accounted for 7% of PM2.5 and the sum of other trace elements was 10%. In the RA tunnel, PM2.5 was on average 233 μg m−3, mostly composed of EC (52%) and OM (39%). Sulphate, crustal and the trace elements showed a minor contribution with 5%, 1%, and 1%, respectively. The average OC : EC ratio in the JQ tunnel was 1.59 ± 0.09, indicating an important contribution of EC despite the high ethanol fraction in the fuel composition. In the RA tunnel, the OC : EC ratio was 0.49 ± 0.12, consistent with previous measurements of diesel-fuelled HDVs. Besides bulk carbonaceous aerosol measurement, polycyclic aromatic hydrocarbons (PAHs) were quantified. The sum of the PAHs concentration was 56 ± 5 ng m−3 and 45 ± 9 ng m−3 in the RA and JQ tunnel, respectively. In the JQ tunnel, benzo(a)pyrene (BaP) ranged from 0.9 to 6.7 ng m−3 (0.02–0.1‰ of PM2.5) whereas in the RA tunnel BaP ranged from 0.9 to 4.9 ng m−3 (0.004–0. 02‰ of PM2.5), indicating an important relative contribution of LDVs emission to atmospheric BaP. Real-time measurements performed in both tunnels provided aerosol size distributions and optical properties. The average particle count yielded 73 000 cm−3 in the JQ tunnel and 366 000 cm−3 in the RA tunnel, with an average diameter of 48 nm in the former and 39 nm in the latter. Aerosol single scattering albedo, calculated from scattering and absorption observations in the JQ tunnel, indicates a value of 0.5 associated with LDVs. Such single scattering albedo is 20–50% higher than observed in previous tunnel studies, possibly as a result of the large biofuel usage. Given the exceedingly high equivalent black carbon loadings in the RA tunnel, real time light absorption measurements were possible only in the JQ tunnel. Nevertheless, using EC measured from the filters, a single scattering albedo of 0.31 for the RA tunnel has been estimated. The results presented here characterise particulate matter emitted from nearly 1 million vehicles fuelled with a considerable amount of biofuel, providing a unique experimental site worldwide.

This study presents the emission profiles of n-alkanes for different vehicular sources in two Brazilian cities. Atmospheric particulate matter was collected in São Paulo (Southeast) and in Salvador (Northeast) to determine n-alkanes. The sites were impacted by bus emissions and heavy and light-duty vehicles. The objective of the present study is to attempt to differentiate the profile of n-alkane emissions for particulate matter (PM) collected at different sites. PM concentrations ranged between 73 and 488 µg m⁻³, and the highest concentration corresponded to a tunnel for light and heavy duty vehicles. At sites where diesel-fueled vehicles are dominant, the n-alkanes show a unimodal distribution, which is different from the bimodal profile observed in the literature. Carbon preference index values corresponded to anthropogenic sources for most of the sites, as expected, but C_max varied comparing to literature and a source signature was difficult to observe. The main sources to air pollution were indicated by principal component analysis (PCA). For PCA, a receptor model often used as an exploratory tool to identify the major sources of air pollutant emissions, the principal factors were attributed to mixed sources and to bus emissions. Chromatograms of four specific samples showed distinct profiles of unresolved complex mixtures (UCM), indicating different contributions of contamination from petroleum or fossil fuel residues, which are unable to resolve by gas chromatography. The UCM area seemed higher in samples collected at sites with the abundance of heavy vehicles.