Electronic devices based on organic thin-film transistors (OTFT) have the potential to supply the demand for portable and low-cost gadgets, mainly as sensors for in situ disease diagnosis and environment monitoring. For that reason, poly(3-hexylthiophene) (P3HT) as the active layer in the widely-used bottom-gate/bottom-contact OTFT structure was deposited over highly-doped silicon substrates covered with thermally-grown oxide to detect vapor-phase compounds. A ten-fold organochloride and ammonia sensitivity compared to bare sensors corroborated the application of this semiconducting polymer in sensors. Furthermore, P3HT TFTs presented approximately three-order higher normalized sensitivity than any chemical sensor addressed herein. The results demonstrate that while TFTs respond linearly at the lowest concentration values herein, chemical sensors present such an operating regime mostly above 2000 ppm. Simultaneous alteration of charge carrier mobility and threshold voltage is responsible for pushing the detection limit down to units of ppm of ammonia, as well as tens of ppm of alcohol or ketones. Nevertheless, P3HT transistors and chemical sensors could compose an electronic nose operated at room temperature for a wide range concentration evaluation (1–10,000 ppm) of gaseous analytes. Targeted analytes include not only biomarkers for diseases, such as uremia, cirrhosis, lung cancer and diabetes, but also gases for environment monitoring in food, cosmetic and microelectronics industries.

Organic thin-film transistors (OTFTs) are miniaturized devices based upon the electronic responses of organic semiconductors. In comparison to their conventional inorganic counterparts, organic semiconductors are cheaper, can undergo reversible doping processes and may have electronic properties chiefly modulated by molecular engineering approaches. More recently, OTFTs have been designed as gas sensor devices, displaying remarkable performance for the detection of important target analytes, such as ammonia, nitrogen dioxide, hydrogen sulfide and volatile organic compounds (VOCs). The present manuscript provides a comprehensive review on the working principle of OTFTs for gas sensing, with concise descriptions of devices’ architectures and parameter extraction based upon a constant charge carrier mobility model. Then, it moves on with methods of device fabrication and physicochemical descriptions of the main organic semiconductors recently applied to gas sensors (i.e., since 2015 but emphasizing even more recent results). Finally, it describes the achievements of OTFTs in the detection of important gas pollutants alongside an outlook toward the future of this exciting technology.

Electrochemical biosensing devices are known for their simple operational procedures, low fabrication cost, and suitable real-time detection. Despite these advantages, they have shown some limitations in the immobilization of biochemicals. The development of alternative materials to overcome these drawbacks has attracted significant attention. Nanocellulose-based materials have revealed valuable features due to their capacity for the immobilization of biomolecules, structural flexibility, and biocompatibility. Bacterial nanocellulose (BNC) has gained a promising role as an alternative to antifouling surfaces. To widen its applicability as a biosensing device, BNC may form part of the supports for the immobilization of specific materials. The possibilities of modification methods and in situ and ex situ functionalization enable new BNC properties. With the new insights into nanoscale studies, we expect that many biosensors currently based on plastic, glass, or paper platforms will rely on renewable platforms, especially BNC ones. Moreover, substrates based on BNC seem to have paved the way for the development of sensing platforms with minimally invasive approaches, such as wearable devices, due to their mechanical flexibility and biocompatibility.

With the current worsening of climate change-associated risks, the transition to low-carbon energy sources has become a global priority. In this context, the advances in the implementation of smart grids, which, in addition to greater efficiency and resilience, also allow greater penetration of renewable distributed energy resources, are becoming increasingly important. However, the necessary investments will be colossal. Many specialists see the process of opening up the electric energy markets as essential to boosting these new technologies. Greater decentralization of the decision-making process can potentially promote greater scalability. However, not all liberalization reforms have led to good results. Several researchers have been evaluating experiences in different countries. Brazil, a country with continental dimensions and peculiar characteristics, already counts with a mostly renewable electric energy generation mix. In recent decades, however, it has become increasingly dependent on fossil fuel sources. Brazil has been conducting a process of opening the electric energy market since the 1990s. This process has faced a series of barriers. This article presents a critical bibliographic review of the Brazilian Power System history and its ongoing opening process, its possible successes and errors, as well as its perspectives and challenges.