1.3- and 1.55-$mu$m vertical-cavity surface-emitting lasers (VCSELs) on InP have been realized. High-reflectivity AlGaInAs–InP lattice matched distributed Bragg reflectors (DBRs) were grown on InP substrates. 1.7 (for 1.3$mu$m) and 2.0 (for 1.55 $mu$m) mW single mode power at 25$^circ$C, 0.6 mW single mode power at 85$^circ$C and lasing operation at$≫hbox100^circ$C have been achieved. 10 Gbit/s error free transmissions through 10 km standard single mode fiber for 1.3-$mu$m VCSELs, and through 15 km nonzero dispersion shift fiber for 1.55-$mu$m VCSELs, have been demonstrated. With the addition of an SOA, 100 km error free transmission at 10 Gbit/s also has been demonstrated through a negative dispersion fiber. No degradation has been observed after over 2500-h aging test.
High efficiency continuous-wave operation of 1.53 µm vertical cavity surface emitting lasers (VCSELs) with buried tunnel junction grown by metal organic chemical vapour deposition (MOCVD) has been demonstrated. Devices show a high differential quantum efficiency of 46% and a singlemode power of 1 mW. Minimum threshold current and voltage are 0.45 mA and 1.3 V at room temperature, respectively for devices of 5 µm diameter.
21 April 2011 in IEEE Journal of Selected Topics in Quantum Electronics
In this paper, the state-of-the art of long-wavelength GaInAsP/InP membrane semiconductor lasers, one of the most promising candidate light sources for optical interconnects and on-chip optical wiring between large-scale integrated circuits, is described. After an extensive review of research activities focused on laser preparation on either Si or Si-on-insulator substrate, the findings of our recent research activities on low power consumption lasers are presented. Specifically, our interest was set on the low-damage fabrication of strongly index-coupled grating, which is generally opted forDFB and distributed reflector (DR) lasers consisting of wire-like active regions, as well as of high index-contrast membrane waveguides. A submilliampere threshold current and a differential quantum efficiency close to 50% from the front facet were achieved in the case of the DR laser. On the other hand, a lateral current injection (LCI) structure, which can be combined with the membrane laser, was adopted for the realization of an injection-type membrane laser. The successful continuous wave operation of LCI lasers, prepared on a semiinsulating InP substrate, was achieved with moderately low threshold current at room temperature.
15 October 2007 in IEEE Journal of Selected Topics in Quantum Electronics
We realized strongly index-coupled membrane buried-heterostructure (BH) distributed-feedback (DFB) lasers fabricated by electron-beam lithography, CH4/H2 reactive-ion etching, and regrowth by organometallic vapor-phase epitaxy, using surface corrugation DFB. First, we fabricated narrow stripe membrane BH-DFB lasers with surface corrugation for stable single-mode operation. Under optically pumped room-temperature continuous-wave (RT-CW) operation, a wide stopband width of 68 nm was observed in spite of the narrow stripe width of 0.6 mum. The corresponding index-coupling coefficient of 2950 cm-1 is over two times larger than that of a flat-surface (conventional) membrane BH-DFB laser with a stripe width of 2.0 mum. In addition, we fabricated a short-cavity membrane DFB laser with a surface corrugation structure. A threshold optical pump power of as low as 0.34 mW was realized for a 2.0-mum-wide and 80-mum-long device under RT-CW conditions.
High-temperature pulsed operation of GaInNAs-GaAs double-quantum-well lasers grown by chemical beam epitaxy has been demonstrated for the first time. The lasing wavelength was from 1.20 to 1.27 μm with different composition at room temperature. The highest lasing operation temperature up to 170/spl deg/C and a high characteristic temperature of 270 K were obtained for 300-μm-long lasers at 1.2 μm.