A recent review of thermography studies in rheumatoid arthritis shows limited data about disease activity and mostly focuses on differences between the thermography of rheumatoid arthritis patients and typical subjects. A retrospective study compared patients with high disease activity (n = 50), moderate disease activity (n = 16), and healthy participants (n = 42), taking into account demographic, clinical, laboratory, and thermography parameters. We applied an infrared thermography sensor and a fingers examination protocol. Outcomes included the mean temperature of five fingers of a hand: In static, post-cooling, post-rewarming, the total change in mean temperature of fingers due to cold provocation, the total change in mean temperature of fingers due to rewarming, the area under the cooling curve, the area under the heating curve, the difference between the area under the rewarming and the cooling curve, and temperature intensity distribution maps. For patients with high disease activity, a lower area under the heating curve and a lower difference between the area under the rewarming curve and the cooling curve were observed, as well as a smaller total change in mean temperature due to rewarming, compared to patients with moderate disease activity (p < 0.05). Our study findings could be helpful in patients with an equivocal clinical examination.
2 November 2019 in Medical & Biological Engineering & Computing
Rheumatoid arthritis (RA) is a chronic inflammatory tissue disease that leads to cartilage, bone, and periarticular tissue damage. This study aimed to investigate whether the use of infrared thermography and measurement of temperature profiles along the hand fingers could detect the inflammation and improve the diagnostic accuracy of the cold provocation test (0 °C for 5 s) and rewarming test (23 °C for180 s) in RA patients. Thirty RA patients (mean age = 49.5 years, standard deviation = 13.0 years) and 22 controls (mean age = 49.8 years, standard deviation = 7.5 years) were studied. Outcomes were the minimal and maximal: baseline temperature (T1), the temperature post-cooling (T2), the temperature post-rewarming (T3), and the Tmax-Tmin along the axis of each finger. The statistical significance was observed for the thumb, index finger, middle finger, and ring finger post-cooling and post-rewarming. Receiver operating characteristics (ROC) analysis to distinguish between the two groups revealed that for the thumb, index finger, middle finger, and ring finger, the area under the ROC curve was statistically significantly (p < 0.05) post-cooling. The cold provocation test used in this study discriminates between RA patients and controls and detects an inflammation in RA patients by the measurement of temperature profiles along the fingers using an infrared camera.
In osteoarthrosis, pathological features of articular cartilage are associated with degeneration and nanomechanical changes. The aim of this paper is to show that indentation-atomic force microscopy can monitor wear-related biomechanical changes in the hip joint of patients with osteoarthritis. Fifty patients (N = 50), aged 40 to 65, were included in the study. The mechanical properties and the submicron surface morphology of hyaline cartilage were investigated using atomic force microscopy. Measurements of the roughness parameters of cartilage surfaces were performed, including the arithmetic average of absolute values (Ra), the maximum peak height (Rp), and the mean spacing between local peaks (S). The arithmetic mean of the absolute values of the height of healthy cartilage was 86 nm, while wear began at Ra = 73 nm. The maximum changes of values of the roughness parameters differed from the healthy ones by 71%, 80%, and 51% for Ra, Rp, and S, respectively. Young’s modulus for healthy cartilage surfaces ranged from 1.7 to 0.5 MPa. For the three stages of cartilage wear, Young’s modulus increased, and then it approached the maximum value and decreased. AFM seems to be a powerful tool for surface analysis of biological samples as it enables indentation measurements in addition to imaging.
The purpose of this study was twofold. Firstly, we proposed a measurement protocol for the atomic force microscopy (AFM) method to determine the nanomechanical properties of articular cartilage in experimental osteoarthritis in rabbits. Then, we verified if mechanical properties can be evaluated with AFM shortly after platelet-rich plasma (PRP) injection. We hypothesized that the modulus determined by AFM indentation experiments could be utilized as a progressive disease marker during the treatment of osteoarthritis. The rabbits were equally divided into three groups of six: control (group 1); injections of saline (0.5 mL) and 10% surgical talc (Talcum Pharmaceutical®, Minsk, Belarus) were delivered into the right knee under the patella (group 2 and 3); and PRP was injected into the right knee (group 3). In group 2, the arithmetic average of absolute values (Ra) change was a 25% increase; the maximum peak height (Rp) increased by over 102%, while the mean spacing between local peaks (S) increased by 28% (p < 0.05). In group 3, Ra increased by 14% and Rp increased by 32%, while S decreased by 75% (p < 0.05). The Young’s modulus of the surface layers decreased by 18% as a result of induced model of osteoarthritis (IMO) (p < 0.05), and it increased by 9% (p < 0.05) as a result of PRP therapy, which means that the mechanical properties of cartilage were partially recovered. This research demonstrates that Young’s modulus utilized on a nanometer scale has potential to be a progressive disease marker during the treatment of osteoarthritis.
BACKGROUND: The traditional rheumatoid arthritis (RA) diagnosis is very complicated because it uses many clinical and image data. Therefore, there is a need to develop a new method for diagnosing RA using a consolidated set of blood analysis and thermography data. OBJECTIVE: The following issues related to RA are discussed: 1) Which clinical data are significant in the primary diagnosis of RA? 2) What parameters from thermograms should be used to differentiate patients with RA from the healthy? 3) Can artificial neural networks (ANN) differentiate patients with RA from the healthy? METHODS: The dataset was composed of clinical and thermal data from 65 randomly selected patients with RA and 104 healthy subjects. Firstly, the univariate logistic regression model was proposed in order to find significant predictors. Next, the feedforward neural network model was used. The dataset was divided into the training set (75% of data) and the test set (25% of data). The Broyden-Fletcher-Goldfarb-Shanno (BFGS) and non-linear logistic function to transformation nodes in the output layer were used for training. Finally, the 10 fold Cross-Validation was used to assess the predictive performance of the ANN model and to judge how it performs. RESULT: The training set consisted of the temperature of all fingers, patient age, BMI, erythrocyte sedimentation rate, C-reactive protein and White Blood Cells (10 parameters in total). High level of sensitivity and specificity was obtained at 81.25% and 100%, respectively. The accuracy was 92.86%. CONCLUSIONS: This methodology suggests that the thermography data can be considered in addition to the currently available tools for screening, diagnosis, monitoring of disease progression.
25 February 2026 in Biocybernetics and Biomedical Engineering