A well-defined resin system is needed to serve as a benchmark for 3D printing of high-performance composites. This work describes the design and characterization of such a system that takes into account processability and performance considerations. The Grunberg–Nissan model for resin viscosity and the Fox equation for polymer Tg were used to determine proper monomer ratios. The target viscosity of the resin was below 500 cP, and the target final Tg of the cured polymer was 150 °C based on tan-δ peak from dynamic mechanical analysis. A tri-component model resin system, termed DA-2 resin, was determined and fully characterized. The printed polymer exhibited good thermal properties and high mechanical strength after post-cure, but has a comparatively low fracture toughness. The model resin will be used in additive manufacturing of fiber reinforced composite materials as well as for understanding the fundamental processing–property relationships in light-based 3D printing.
The use of isosorbide-derived polymers has garnered significant attention in recent decades as a high-performance, renewable material sourced from biomass. Of particular interest is isosorbide methacrylate, which possesses low viscosity (4 GPa). These characteristics present a promising opportunity to replace BPA-derived methacrylate compounds in various applications. This investigation aims to synthesize and characterize isosorbide-based low-viscosity resin systems for 3D printing. The resin blends are composed of isosorbide methacrylate and two bio-renewable methacrylates, furfuryl methacrylate (FM) and bis-hydroxymethyl-furan methacrylate (BHMF-M), polymerized through a digital light processing (DLP) technique. The addition of the bio-based co-monomers serves to enhance the fracture toughness of the brittle isosorbide methacrylate crosslinked homopolymer (GIc = 37 J/m2). The resulting polymers exhibit Tg values greater than 200 °C and GIc around 100 J/m2. These resin systems hold potential for imparting high bio-based content to polymers used in additive manufacturing for high-performance applications.