The objective of this study is to develop a new formulation for predicting the permanent local denting damage of steel ring and/or stringer-stiffened cylinders under dynamic lateral mass impact. The considered scenarios could represent the collisions of offshore cylindrical structures with bow or stern of service vessels or floating objects. Before deriving the formulations, the numerical methods were developed using ABAQUS/Explicit to determine the deformation of these stiffened cylinder structures subjected to dynamic lateral mass impact. Next, rigorous parametric studies were performed on the actual design full-scaled stiffened cylinder examples using the developed numerical method. Based on the rigorous numerical results, new simple design formulations to predict the maximum permanent local dent depth of a stiffened cylinder are derived through a regression study as the function of a non-dimensional energy parameter. The accuracy and reliability of the derived formulations are confirmed by comparison with the available test results, nonlinear FEA and existing analytical, and empirical equations in the literature. A good agreement with existing test data for ship-offshore structure collisions was achieved.

The residual strength capacity of ship hull with full corrosion appearance in every structural member has been considered in a large number of research works; however, the influence of local corrosion on the ultimate strength and cross-section properties has not been taken into account and analyzed. Hence, this study aims to assess the effect of corrosion appearance in the flange section and web section on the ultimate vertical bending moment and several cross-section properties of a bulk carrier. To perform this task, a probabilistic corrosion rate estimation model and the common structural rule model are introduced and employed. The incremental-iterative method given by the International Association of Classification Societies-Common Structural Rules (IACS-CSR) is applied to determine the ultimate vertical bending moment, neutral axis position at the limit state, and other properties of the cross-section. The calculation results and discussions relative to the effect of corrosion on ship hull are presented.

The article describes possible solutions of the problem connected with shortening shipbuilding construction time as well as reducing production costs. To reduce the total amount of labour involved in the manufacture and installation of ship piping systems, which is 20% compared to the total labour volume of shipbuilding, authors provide the research on the possibility of manufacturing straight pipe sections with permissible deviations in combination with free flanges, analysis of deviation compensation for pipelines through the use of straight pipe sections manufactured with permissible tolerance and proposing new theoretical solutions to improve manufacturing and installing ship piping systems. Introduction of these technologies contributes to reduction of cycles of building and decrease in labour-intensiveness of pipeline works when carrying out marine orders. The chart of modeling the system of pipelines is presented. A straight pipe manufactured with an allowable deflection on a flat support and a loose flange attached to the end of the welded pipe are shown. The scheme of a permissible deviation α at mounting the connections between pipes is considered. The possibility of assembling curved pipelines using straight pipe sections is described in detail. The compensation zone is illustrated using the rotation of two pairs of deflected straight pipes. A block diagram of the application of research results in manufacturing and mounting a pipeline system has been developed