Asphaltenes have been associated with a number of problems in the petroleum industry with regard to the storage, exploration, and transportation of petroleum crude. In the current work, Copper-BenzeneDiCarboxylic acid (Cu-BDC) and Cu-BDC derived metal oxide has been used in the removal and oxidation of the asphaltenes. The MOF derived metal oxide was confirmed to be Cu2O. Though adsorption of asphaltenes followed a Langmuir adsorption isotherm in both cases, Cu-BDC was superior to Cu2O with an adsorption capacity four times that of the adsorption capacity of Cu2O. Also, the kinetic studies showed that the adsorption kinetics followed pseudo second order adsorption kinetics in both cases. From the oxidation studies, it was found that Cu-BDC was unstable beyond 350 °C and had no role in catalyzing the oxidation reaction. The Cu2O, however, was successful at catalyzing the asphaltene oxidation reaction and a reduction of 50 °C in oxidation temperature was observed. Hence comparing Cu-BDC with Cu2O, MOF was successful in the adsorption reaction but the MOF derived metal oxide had the upper hand in the oxidation reaction.
Efficient catalysts for soot oxidation are critical for mitigating environmental pollution. In this study, CoMn2O4 spinel catalysts were synthesised using reverse co-precipitation and co-precipitation methods to evaluate their performance in soot oxidation and kinetic behaviour. All samples exhibited a tetragonal phase (XRD) and spherical morphology with rough surfaces (SEM). Raman spectroscopy confirmed structural disorder and oxygen vacancies, while XPS analysis revealed the presence of low-valence Mn ions, facilitating oxygen vacancy formation critical for soot oxidation. Additionally, the co-existence of Co and Mn ions contributed to a synergistic effect, enhancing the catalytic properties of the spinel structure. The reverse co-precipitation method produced a catalyst with a higher concentration of oxygen vacancies and active oxygen species among the samples. This sample demonstrated superior catalytic performance, achieving a T50% of 424 °C, low activation energy (153 kJ/mol) and pre-exponential factor (25 min− 1). Soot TPR analysis highlighted the role of catalyst reducibility, while thermogravimetric analysis revealed that activation energy and pre-exponential factors were influenced by surface composition. These findings provide valuable insights into the design of efficient catalysts for soot oxidation, emphasising the importance of synthesis methods and surface characteristics.
6 August 2018 in Asia-Pacific Journal of Chemical Engineering