Livestock already use most global agricultural land, whereas the demand for animal-source food (ASF) is expected to increase. To address the contribution of livestock to global food supply, we need a measure for land use efficiency of livestock systems. Existing measures capture different aspects of the debate about land use efficiency of livestock systems, such as plant productivity and the efficiency of converting feed, especially human-inedible feed, into animal products. So far, the suitability of land for cultivation of food crops has not been accounted for. Our land use ratio (LUR) includes all above-mentioned aspects and yields a realistic insight into land use efficiency of livestock systems. LUR is defined as the maximum amount of human-digestible protein (HDP) derived from food crops on all land used to cultivate feed required to produce 1 kg ASF over the amount of HDP in that 1 kg ASF. We illustrated our concept for three case systems. The LUR for the case of laying hens equaled 2.08, implying that land required to produce 1 kg HDP from laying hens could directly yield 2.08 kg HDP from human food crops. For dairy cows, the LUR was 2.10 when kept on sandy soils and 0.67 when kept on peat soils. The LUR for dairy cows on peat soils was lower compared to cows on sandy soils because land used to grow grass and grass silage for cows on peats was unsuitable for direct production of food crops. A LUR <1.0 is considered efficient in terms of global food supply and implies that animals produce more HDP per square metre than crops. Values <1.0 demonstrate that livestock produce HDP more efficiently than crops. Such livestock systems (with a LUR < 1.0), therefore, do have a role in future food supply and therefore contribute to food security. Our LUR offers identification of livestock production systems that contribute to global food supply, i.e. systems that value land with low opportunity costs for arable production and/or by-products from crop cultivation or the food or energy industry.
When cows on dairy farms are milked with an automatic milking system or in high capacity milking parlors, clinical mastitis (CM) cannot be adequately detected without sensors. The objective of this paper is to describe the performance demands of sensor systems to detect CM and evaluats the current performance of these sensor systems. Several detection models based on different sensors were studied in the past. When evaluating these models, three factors are important: performance (in terms of sensitivity and specificity), the time window and the similarity of the study data with real farm data. A CM detection system should offer at least a sensitivity of 80% and a specificity of 99%. The time window should not be longer than 48 hours and study circumstances should be as similar to practical farm circumstances as possible. The study design should comprise more than one farm for data collection. Since 1992, 16 peer-reviewed papers have been published with a description and evaluation of CM detection models. There is a large variation in the use of sensors and algorithms. All this makes these results not very comparable. There is a also large difference in performance between the detection models and also a large variation in time windows used and little similarity between study data. Therefore, it is difficult to compare the overall performance of the different CM detection models. The sensitivity and specificity found in the different studies could, for a large part, be explained in differences in the used time window. None of the described studies satisfied the demands for CM detection models.
Contamination with SE is an important threat to food safety in egg production. Various risk factors exist for infection with and spreading of SE on a farm. A data set of regularly collected blood samples from hens at the end of lay was available for analysis. Data included information about infection with SE, date of sampling, housing system and flock size and whether there were hens of different ages on the farm or in the house. By using the mentioned data set, our objective was to identify risk factors associated with SE infection in laying hens. Multiple logistic regression was used to assess the contribution of different variables. Results showed that bigger flocks increased the chance of infection with SE in all housing systems. The system with the lowest chance of infection was the cage system with wet manure. An outdoor run increased the chance of infection only at farms with all hens of the same age. The presence of hens of different ages on a farm was a risk factor for deep litter systems only. This resulted in the highest chance of infection for a deep litter system on a farm with hens of different ages. On a farm with all hens of the same age, however, a deep litter system did not increase the chance of infection with SE compared with a cage system. The main risk factors associated with SE infection, therefore, were flock size, housing system, and farm with hens of different ages.
1. On-farm quantification of sustainability indicators (SI) is an effective way to make sustainable development measurable. The egg production sector was used as a case study to illustrate this approach. 2. The objective was to select SI for economic, ecological and societal issues, and to analyse the performance on selected SI of different production systems. 3. For the case study, we compared 4 egg production systems, characterised by differences in the housing systems which are most common in the Netherlands: the battery-cage system, the deep-litter system with and without outdoor run, and the aviary system with outdoor run. 4. Based on a clear set of criteria, we selected SI for animal welfare, economics, environmental impact, ergonomics and product quality. 5. We showed that on-farm quantification of SI was an appropriate method to identify the strengths and weaknesses of different systems. 6. From this analysis it appears that the aviary system with outdoor run is a good alternative for the battery-cage system, with better scores for the aviary system on animal welfare and economics, but with worse scores on environmental impact.
The objective was to develop and validate a clinical mastitis (CM) detection model by means of decision-tree induction. For farmers milking with an automatic milking system (AMS), it is desirable that the detection model has a high level of sensitivity (Se), especially for more severe cases of CM, at a very high specificity (Sp). In addition, an alert for CM should be generated preferably at the quarter milking (QM) at which the CM infection is visible for the first time. Data were collected from 9 Dutch dairy herds milking automatically during a 2.5-yr period. Data included sensor data (electrical conductivity, color, and yield) at the QM level and visual observations of quarters with CM recorded by the farmers. Visual observations of quarters with CM were combined with sensor data of the most recent automatic milking recorded for that same quarter, within a 24-h time window before the visual assessment time. Sensor data of 3.5 million QM were collected, of which 348 QM were combined with a CM observation. Data were divided into a training set, including two-thirds of all data, and a test set. Cows in the training set were not included in the test set and vice versa. A decision-tree model was trained using only clear examples of healthy (n=24,717) or diseased (n=243) QM. The model was tested on 105 QM with CM and a random sample of 50,000 QM without CM. While keeping the Se at a level comparable to that of models currently used by AMS, the decision-tree model was able to decrease the number of false-positive alerts by more than 50%. At an Sp of 99%, 40% of the CM cases were detected. Sixty-four percent of the severe CM cases were detected and only 12.5% of the CM that were scored as watery milk. The Se increased considerably from 40% to 66.7% when the time window increased from less than 24h before the CM observation, to a time window from 24h before to 24h after the CM observation. Even at very wide time windows, however, it was impossible to reach an Se of 100%. This indicates the inability to detect all CM cases based on sensor data alone. Sensitivity levels varied largely when the decision tree was validated per herd. This trend was confirmed when decision trees were trained using data from 8 herds and tested on data from the ninth herd. This indicates that when using the decision tree as a generic CM detection model in practice, some herds will continue having difficulties in detecting CM using mastitis alert lists, whereas others will perform well.