An autonomous surface vehicle, known as a wave glider, was used to record refracted and reflected signals from a seismic source penetrating the shallow subsurface. An integrated survey system consisting of a wave gilder and a human-operated source vessel was deployed. These survey systems are used to acquire wide-offset seismic survey data from specific areas, such as offshore structures. The wave gliders can collect seismic refraction and reflection data, which can be used to estimate subsurface information, e.g., acoustic wave velocity and subsurface structure. We processed raw data collected by a receiver equipped with the wave glider and used the relationship between travel time and offset distance to calculate the velocities of shallow sedimentary deposits and the acoustic basement. The velocities of the sedimentary deposits and basement were estimated to be 1557 and 3507 m/s, respectively. We then overlaid the velocities on subsurface data measured using a single-channel streamer. Our results indicate that unmanned equipment can be used for ocean exploration to aid offshore energy development.

The focus of this study was the Baekdusan-Kita 1 (B-KY1) eruption during the late Middle Pleistocene. We identified B-KY1 tephra between the Toya and Aso-1 tephras in the ODP 794A core from the Japan Basin of the East Sea/Japan Sea. The stratigraphic position of the B-KY1 tephra correlated exactly with the first B-KY1 to be identified, in the 20EEZ-1 core from the Kita–Yamato Trough. However, B-KY1 tephra in the ODP 794A core showed a wide range of geochemical compositions. The textural characteristics of B-KY1 tephra in the ODP 794A core was characterized by higher content of fine-grained bubble-wall shards than that of the B-KY1 tephra in the 20EEZ-1 core. The difference in B-KY1 tephra between the two coring sites may reflect shifts in wind direction during volcanic eruptions. We refined the eruption age of the B-KY1 tephra by examining distinct sedimentary facies related to the start of the penultimate deglaciation of this region at ca. 135 ka. The findings of this study suggest that the compositional diversity of B-KY1 tephra may have been influenced by subsequent mixing of comendite and comenditic trachyte magma with injected pantelleritic magma during the late Middle Pleistocene Baekdusan volcanic eruption.

Natural gas hydrates (GHs) filling sand layer pores are the most promising GHs that can be produced via conventional mechanisms in deep-sea environments. However, the seismic tracking of such thin GH-bearing sand layers is subject to certain limitations. For example, because most GH-bearing sand layers are thin and sparsely interbedded with mud layers, conventional seismic data with a maximum resolution of ~10 m are of limited use for describing their spatial distribution. The 2010 Ulleung Basin drilling expedition identified a relatively good GH reservoir at the UBGH2-6 site. However, the individual GH-bearing sand layers at this site are thin and cannot therefore be reliably tracked using conventional seismic techniques. This study presents a new thin layer tracking method using stepwise seismic inversion and 3D seismic datasets with two different resolutions. The high-resolution acoustic impedance volume obtained is then used to trace thin layers that cannot be harnessed with conventional methods. Moreover, we estimate the high-resolution regional GH distribution based on GH saturation derived from acoustic impedance at UBGH2-6. The thin GH layers, previously viewed as a single layer because of limited resolution, are further subdivided, traced, and characterized in terms of lateral variation.