The stored energy and activation energy for recrystallization were investigated for a Cu-Ni-Si alloy after high-pressure torsion processing for N = ½, 1, 5 and 10 turns at room temperature. The contributions of geometrically necessary dislocations (GNDs), statistically stored dislocations (SSDs) and vacancies to the stored energy were calculated through the Vickers microhardness measurements, kernel average misorientation (KAM) measurements and an analysis by differential scanning calorimetry (DSC). The results show that the total stored energy decreases rapidly after equivalent strain of εeq ∼ 9 and then saturates through εeq ∼ 86 at ∼70 J/mol. Concurrently, the local stored energy in GNDs and SSDs was found to depend strongly on the radial distance from the centre of the disc and increase with increasing equivalent strain at εeq ∼ 16 and saturate with further straining. Accordingly, the results indicate that the GNDs and vacancies are responsible for the high stored energy in the initial stage of deformation at equivalent strain range of εeq = 8.6–16 and thereafter their contribution decreases slightly due to the occurrence of dynamic recrystallization and the formation of fine grains. At the same time, the contribution of the SSDs is similar to that of the GNDs only in high strain deformation as at εeq = 49.3 to accommodate the deformation process. An activation energy for recrystallization was estimated in the range of ∼ 89.7–98.7 kJ/mol, thereby suggesting poor thermal stability.
The local microstructure, texture gradient and mechanical properties through the shoulder dimension (10 mm) of upper and lower AA5182 aluminum sheets were investigated using electron backscatter diffraction (EBSD) and Vickers microhardness after friction stir spot welding (FSSW). Based on the microstructural features (mean grain size, grain boundary type and dynamic recrystallization (DRX)), the upper sheet was found to be mainly composed of the stir zone (SZ) and thermomechanically affected zone (TMAZ) due to the high deformation induced simultaneously by the tool rotation and the shoulder download force, while the SZ, TMAZ, heat-affected zone (HAZ) and base metal (BM) were detected in the lower sheet due to the limited effect of the shoulder on the lower sheet. The texture changes, due to the nature of the deformation, demonstrated a shear-type texture at the SZ to a plane strain compression deformation type texture at the TMAZ and then a recrystallization texture at the HAZ and BM. The microhardness gradually decreased with the increasing distance from the keyhole along the SZ, TMAZ and HAZ regions. Eventually, the microstructure and microhardness evolutions were correlated based on the Hall–Petch relationship.