Large database of high resolution Kβ X-ray emission spectra of selected 3d metal (Ti, V, Cr, Mn) compounds obtained after excitation by 2 and 3 MeV proton beams have been built. Analysis of (relative) positions and intensities of Kβ′′ and Kβ2,5 X-ray contributions as a function of chemical and structural properties of analyzed 3d metal compounds have been performed. Two independent experiments employing wavelength dispersive spectrometers with different experimental resolutions (8.1 eV versus 2.8 eV for the case of Cr Kβ1,3 line FWHM) were performed in order to exclude any possible effect of the experimental resolution on the extracted values. A simple parametrization of Kβ′′ and Kβ2,5 X-rays' relative positions and intensities over the range of 3d metal compounds with various oxidation states, a wide range of metal–ligand bond lengths, and selected 3d metals, was performed. Results of our parametrization were compared critically with other experimental and theoretical values available in the literature. The parametrization obtained in this work could be used for chemical and structural speciation of 3d metal compounds and for improved interpretation of K X-ray spectra of 3d transition metal compounds measured by solid state detectors.
We report on the electrical properties of glasses with nominal composition xB2O3–(100 − x)[40Fe2O3–60P2O5],x = 2–20, mol.%. The conduction transport in these glasses is polaronic and shows a strong dependence on Fe2O3 content and polaron number density. The changes in DC conductivity are found not to be directly related to B2O3, however structural changes induced by its addition impact frequency-dependent conductivity. All glasses obey Summerfield and Sidebottom procedures of scaling conductivity spectra indicating that the polaronic mechanism does not change with temperature. An attempt to produce a super-master curve revealed that shape of the conductivity dispersion is the same for glasses with up to 15.0 mol.% B2O3 but differs for glass with the highest B2O3 content. This result could be related to the presence of borate units in the glass network. Moreover, the spatial extent of localized polaron motions increases with the decrease of polaron number density, however, this increase shows a larger slope than for previously reported iron phosphate glasses most probably due to the influence of B2O3 on glass structure and formation of polarons. While Summerfield scaling procedure fails, Sidebottom scaling yields a super-master curve, which indicates that polaronic hopping lengths also change with changing polaron number density in these glasses.
29 August 2013 in Journal of Analytical Atomic Spectrometry
Nowadays quantitative analysis in energy dispersive X-ray Emission Spectroscopy is usually performed by the “fundamental parameter approach”. Such an approach generally relies upon a good knowledge of fundamental physical parameters. As a rule none of the algorithms in use by laboratories performing routine analysis account for possible chemical effects on X-ray intensity ratios or energies. Here we tested the possible influence of such practice on reliability in the routine analysis of thick pellet samples containing transition metal compounds. A number of samples were prepared by mixing various proportions of MnO2, KMnO4, and Co3O4 (sets A–B) or Cr2O3, K2Cr2O7, and Fe2O3 (C–D). The samples were irradiated by 2 MeV proton beams and proton induced X-ray emission spectra were analyzed by a “fundamental parameter” approach using the GUPIXWIN code. The main interest has been to test the possibility of false Fe detection in the presence of large Mn and Co peaks (sets A–B) and/or Mn in the presence of large Cr and Fe peaks (sets C–D). The results of the analyses indicate false hits of Fe (sets A–B), and larger reported Mn concentrations than expected (sets C–D). However, in all the cases the reported concentrations for Fe or Mn are in between the limits of detection and quantitation. The influence of surface roughness and other effects have been discussed.