We report systematic efficiency variations of green-emitting CdSe@ZnS quantum-dot (QD) LEDs (QLEDs) in response to in situ treatments with 1,2-ethanedithiol (EDT) solutions at various concentrations. The main effect of in situ EDT treatment on a QD layer spin-coated onto a ZnO layer was vacuum-level shift due to dipole moments on the surface of the QD layer and at the interface between QD and ZnO layers. Competing contributions of these dipole moments were responsible for changes in energy level configurations and, accordingly, electron and hole barriers that resulted in discrepancies in electron- and hole-current variations. QLED efficiency was best when treated with an EDT solution of 4 mM, attributable to the largest increase in the hole- to electron current ratio. The maximum luminous yield of the 4 mM EDT-treated QLED was 5.43 cd A−1, which is 10 times higher than that of an untreated device. Furthermore, the luminous yield of this treated device remained as high as 2.56 cd A−1 at a luminance of 500 cd m−2.
We report a five-fold luminance increase of green-light-emitting CdSe@ZnS quantum-dot LEDs (QLEDs) in response to treatment with a 2-ethoxyethanol solution of cesium carbonate (Cs 2 CO 3 ). The maximum luminous yield of Cs 2 CO 3 -treated QLED is as high as 3.41 cd A −1 at 6.4 V. To elucidate device-performance improvement, we model measured currents as the sum of radiative and non-radiative recombination components, which are respectively represented by modified Shockley equations. Variations in model parameters show that a shift in Fermi level, reduction of barrier heights, and passivation of mid-gap defect states are the main results of Cs 2 CO 3 treatment. In spite of a large luminance difference, light-extraction efficiency remains the same at 9% regardless of Cs 2 CO 3 treatment because of the similarity in optical structures.
We report on a substantial increase in luminance and luminous efficiency of green-light emitting devices (LEDs) that use colloidal CdSe@ZnS quantum dots (QDs) as a light-emitting material in response to treatment with 1,2-ethanedithiol (EDT). The maximum luminance increased from 1146 to 8075 cd m −2 , and luminous yield from 0.15 to 1.41 cd A −1 as a result of treating an incomplete device with drops of EDT right after spin-coating QDs onto a ZnO-nanoparticle layer. Based on systematic studies on substrate-dependent change in photoluminescence, and current-voltage and luminance–voltage characteristics, we propose that passivation of intra-gap defect states and relative shifts of energy levels relevant to the operation of QD LEDs are two main results of EDT treatment. In particular, we argue that energy-level shift without emission-color change can be attributed to surface-dipole effects.