ZnO nanoparticles at different pH were synthesised by a sol-gel technique from zinc acetate dihydrate at a calcination temperature of 450 °C. The synthesized ZnO nanoparticles were characterised by x-ray diffraction (XDR) peak profile analysis, high-resolution scanning electron microscopy and Fourier transform infrared spectroscopy. The effects of solution pH on the crystallite size using Williamson-Hall and Debye–Scherrer were determined. The XRD analysis of the zincite phase structure of ZnO nanoparticles was obtained in the form of spheres for all the samples. The average crystallite sizes of ZnO nanoparticles decrease with increasing pH. The crystallite sizes of ZnO nanoparticles were investigated using Williamson-Hall analysis and Scherrer’s formula. The parameters such as dislocation density and lattice strain were computed for the diffraction peaks of XRD in the range of 2 θ = 10–90°. The results showed that the crystallite sizes calculated from Scherrer’s equation and Williamson-Hall analysis from XRD are not inter-correlated. Both methods give a wide deviation of crystallite size. Also, it was found that the crystallite sizes using both methods decrease with an increase in pH. Smaller crystallite sizes were estimated using the Scherrer’s formula. Thus, it is deduced that the equation fitted well for the synthesised ZnO nanoparticles.

This research investigated the removal of heavy metals (As, Pb, Cr, Cd, Ni, Cu, Fe, and Zn) via batch adsorption process from industrial electroplating wastewater using two different nano-adsorbents; purified carbon nanotubes (P-CNTs) and polyhydroxylbutyrate functionalized carbon nanotubes (PHB-CNTs), both produced through catalytic chemical vapour deposition (CCVD) method. HRSEM, HRTEM, XRD, DLS, BET, FTIR, XPS, TGA, pH drift and Raman spectroscopy were used to characterize the developed nano-adsorbents. In the batch adsorption process, the effects of contact time, dosage, temperature and pH were studied. Both nano-adsorbents gave optimum contact time, equilibrium time, optimum dosage, and pH of 10 minutes, 70 minutes, 20 mg, and 5.63–5.65 respectively. The heavy metals removal efficiencies by the nano-adsorbents followed the order of PHB-CNTs > P-CNTs based on ion exchange and electrostatic forces mechanism. For P-CNTs and PHB-CNTs, the equilibrium sorption isotherm suits temkin model, kinetic data fitted to pseudo-second order based on the linear regression correlation coefficient, and the thermodynamic study established spontaneity and endothermic nature of the adsorption process. The findings in this research conclude that both nano-adsorbents have exceptional capacity to remove heavy metals from the adsorbate, with PHB-CNTs possessing better quality. The treated adsorbate meets the standard for industrial or irrigation re-use.