In the European Union, nitrate vulnerable zone (NVZ) should be designed for the mitigation of nitrate (NO3-) contamination caused by agricultural practices. Before establishing new NVZ, the sources of NO3- must be recognized. A geochemical and multiple stable isotopes approach (hydrogen, oxygen, nitrogen, sulfur and boron) and statistical tools were applied to define the geochemical characteristics of groundwater (60 samples), calculate the local NO3- threshold and assess potential sources of NO3- contamination in two study areas (hereafter Northern and Southern), located in a Mediterranean environment (Sardinia, Italy). Results of the integrated approach applied to two case study, permits to highlight the strengths of integrating geochemical and statistical methods to provide nitrate source identification as a reference by decision makers to remediate and mitigate nitrate contamination in groundwater. Hydrogeochemical features in the two study areas were similar: near neutral to slightly alkaline pH, electrical conductivity in the range of 0.3 to 3.9 mS/cm, and chemical composition ranging from Ca-HCO3- at low salinity to Na-Cl- at high salinity. Concentrations of NO3- in groundwater were in the range of 1 to 165 mg/L, whereas the nitrogen reduced species were negligible, except few samples having NH4+ up to 2 mg/L. Threshold values in the studied groundwater samples were between 4.3 and 6.6 mg/L NO3-, which was in agreement with previous estimates in Sardinian groundwater. Values of δ34S and δ18OSO4 of SO42- in groundwater samples indicated different sources of SO42-. Sulfur isotopic features attributed to marine SO42- were consistent with groundwater circulation in marine-derived sediments. Other source of SO42- were recognize due to the oxidation of sulfide minerals, to fertilizers, manure, sewage fields, and SO42- derived from a mix of different sources. Values of δ15N and δ18ONO3 of NO3- in groundwater samples indicated different biogeochemical processes and NO3- sources. Nitrification and volatilization processes might have occurred at very few sites, and denitrification was likely to occur at specific sites. Mixing among various NO3- sources in different proportions might account for the observed NO3- concentrations and the nitrogen isotopic compositions. The SIAR modeling results showed a prevalent NO3- source from sewage/manure. The δ11B signatures in groundwater indicated the manure to be the predominant NO3- source, whereas NO3- from sewage was recognized at few sites. Geographic areas showing either a predominant process or a defined NO3- source where not recognize in the studied groundwater. Results indicate widespread contamination of NO3- in the cultivated plain of both areas. Point sources of contamination, due to agricultural practices and/or inadequate management of livestock and urban wastes, were likely to occur at specific sites.
Coastal retreat is a non-recoverable phenomenon that—together with a relevant proneness to landslides—has economic, social and environmental impacts. Quantitative data on geological and geomorphologic features of such areas can help to predict and quantify the phenomena and to propose mitigation measures to reduce their impact. Coastal areas are often inaccessible for sampling and in situ surveys, in particular where steeply sloping cliffs are present. Uses and capability of infrared thermography (IRT) were reviewed, highlighting its suitability in geological and landslides hazard applications. Thanks to the high resolution of the cameras on the market, unmanned aerial vehicle-based IRT allows to acquire large amounts of data from inaccessible steep cliffs. Coupled structure-from-motion photogrammetry and coregistration of data can improve accuracy of IRT data. According to the strengths recognized in the reviewed literature, a three-step methodological approach to produce IRTs was proposed.
1 June 2020 in Construction and Building Materials
The mechanical strength is a fundamental characteristic of rock masses that can be empirically related to a number of properties and to the likelihood of instability phenomena. Direct field acquisition of mechanical information on tall cliffs, however, is challenging, particularly in coastal and alpine environments. Here, we propose a method to evaluate the compressive strength of rock blocks by monitoring their thermal behaviour over a 24-h period by infrared thermography. Using a drone-mounted thermal camera and a Schmidt (rebound) hammer, we surveyed granitoid and aphanitic blocks in a coastal cliff in south-east Sardinia, Italy. We observed a strong correlation between a simple cooling index, evaluated in the hours succeeding the temperature peak, and strength values estimated from rebound hammer test results. We also noticed different heating-cooling patterns in relation to the nature and structure of the rock blocks and to the size of the fractures. Although further validation is warranted in different morpho-lithological settings, we believe the proposed method may prove a valid tool for the characterisation of non-directly accessible rock faces, and may serve as a basis for the formulation, calibration, and validation of thermo-hydro-mechanical constitutive models.
One of the crucial challenges of our time is climate change. The consequences of rising sea levels and drought greatly impact water resources, potentially worsening seawater intrusion. Characterizing coastal aquifers is an essential step in devising strategies to address these phenomena. Seawater intrusion poses a critical socio-economic and environmental issue in the coastal plain of Muravera, southeastern Sardinia (Italy). This coastal plain is an important agricultural area in Sardinia, and the health of the crops is compromised by the increasing salinization of shallow groundwater. To enhance our understanding of the hydrogeological conceptual model, which is essential for a sustainable resource management system, hydrogeological investigations were conducted and complemented by the chemical and multi-isotopic analyses of groundwater. The main objectives of this study were to identify groundwater recharge areas, understand salinization mechanisms and trace the evolution of water chemistry. Within this framework, a monthly survey monitoring piezometric level and electrical conductivity was carried out for one year. This survey was integrated with chemical and isotope analyses, including δ18OH2O and δ2HH2O, δ11B, δ18OSO4, δ34SSO4, and 87Sr/86Sr. Hydrochemistry analysis results revealed the occurrence of seawater–freshwater mixing, extending up to 4 km inland. H2O isotope analysis confirmed the mixing processes and indicated the meteoric origin of recharge waters for both shallow and semi-confined aquifers. The strontium isotopes ratio facilitated the identification of four main groundwater flow paths, confirmed by the SIAR model. The results of this combined hydrogeological–geochemical–isotopic survey provide essential elements for the future implementation of an integrated and sustainable management system. These findings enable interventions to slow the process of seawater intrusion and meet the economic needs for the development of local communities.
Radon (222Rn) and thoron (220Rn) account for almost two-thirds of the annual average radiation dose received by the Irish population. A detailed study of natural radioactivity levels and radon and thoron exhalation rates was carried out in a legislatively designated “high radon” area, as based on existing indoor radon measurements. Indoor radon concentrations, airborne radiometric data and stream sediment geochemistry were collated, and a set of soil samples were taken from the study area. The exhalation rates of radon (E222Rn) and thoron (E220Rn) for collected samples were determined in the laboratory. The resultant data were classified based on geological and soil type parameters. Geological boundaries were found to be robust classifiers for radon exhalation rates and radon-related variables, whilst soil type classification better differentiates thoron exhalation rates and correlated variables. Linear models were developed to predict the radon and thoron exhalation rates of the study area. Distribution maps of radon and thoron exhalation rates (range: E222Rn [0.15–1.84] and E220Rn [475–3029] Bq m−2 h−1) and annual effective dose (with a mean value of 0.84 mSv y−1) are presented. For some parts of the study area, the calculated annual effective dose exceeds the recommended level of 1 mSv y−1, illustrating a significant radiation risk. Airborne radiometric data were found to be a powerful and fast tool for the prediction of geogenic radon and thoron risk. This robust method can be used for other areas where airborne radiometric data are available.