Herein, Fe-doped C3N4 high-performance photocatalysts, synthesized by a facile and cost effective heat stirring method, were investigated systematically using powder X-ray diffraction (XRD), Fourier transform infrared (FTIR), scanning electron microscopy (SEM) and Brunauer–Emmett–Teller (BET) surface area measurement, X-ray photoelectron (XPS), UV–Vis diffusion reflectance (DRS) and photoluminescence (PL) spectroscopy. The results showed that Fe ions incorporated into a g-C3N4 nanosheet in both +3 and +2 oxidation states and in interstitial configuration. Absorption edge shifted slightly toward the red light along with an increase of absorbance in the wavelength range of 430–570 nm. Specific surface area increased with the incorporation of Fe into g-C3N4 lattice, reaching the highest value at the sample doped with 7 mol% Fe (FeCN7). A sharp decrease in PL intensity with increasing Fe content is an indirect evidence showing that electron-hole pair recombination rate decreased. Interestingly, Fe-doped g-C3N4 nanosheets present a superior photocatalytic activity compared to pure g-C3N4 in decomposing RhB solution. FeCN7 sample exhibits the highest photocatalytic efficiency, decomposing almost completely RhB 10 ppm solution after 30 min of xenon lamp illumination with a reaction rate approximately ten times greater than that of pure g-C3N4 nanosheet. This is in an agreement with the BET measurement and photoluminescence result which shows that FeCN7 possesses the largest specific surface area and low electron-hole recombination rate. The mechanism of photocatalytic enhancement is mainly explained through the charge transfer processes related to Fe2+/Fe3+ impurity in g-C3N4 crystal lattice.
In this study, we developed a green and easy to scale up approach for producing Au/g-C3N4 (Au/GCN) hybrid plasmonic photocatalyst without using the chemical reducing agents via the growing of Au nanoparticles (Au NPs) on the surface of GCN nanosheets under the photo-reduction of ultraviolet (UV)-radiation. Different characterization techniques were conducted for investigating the structure, morphology, surface chemistry and optical properties of the as-prepared catalysts. The scanning electron microscope image shows that the homogeneous Au NPs anchored on the surface of the GCN nanosheet increased with the UV illumination time. The x-ray photoelectron spectroscopy results prove the coexistence of GCN nanosheets with heptazine heterocyclic ring (C6N7) units and Au NPs in the Au/GCN. The photoluminescence intensity decreased sharply with the time of UV irradiation, indicating that the recombination rate of photogenerated electron–hole recombination decreased. The photocatalytic activity of the hybrid catalysts was evaluated by degrading rhodamine B (RhB) under simulated sunlight irradiation. The results show that the Au/GCN photocatalyst exhibits superior sunlight photocatalytic activity than that of bare GCN. The 6 h irradiated fabricating sample exhibited the strongest photocatalytic activity, completely decomposing the 10 ppm RhB in 30 min of irradiation. This report can provide the design of a simple and green synthesis method for the highly active Au/GCN photocatalyst.
We report on the synthesis of Fluorine (F) doped -ZnWO4 photocatalysts and the influence of F-doping on their structure, morphology, optical and photocatalytic properties. A two-step process was used to produce F-doped ZnWO4 photocatalysts. The quality of synthesized materials was characterized using different analytical methods, such as X-ray diffraction analysis, field emission scanning electron microscopy (FE-SEM), energy dispersive X-ray spectroscopy (EDS), Fourier transform infrared spectra (FTIR), as well as photoluminescence (PL) measurement. It was found that the photocatalyst morphology and band gap energy strongly depend on the F-doping concentration. The band gap energy of the photocatalysts decreased when increasing F-doping concentration, and reached a lowest value at a concentration of 4 mol%, and then increased thereafter. At 4 mol% of F-doping, nanowires were formed with approximately 1 μm in length and 50 nm in diameter. On the contrary, others F-doped ZnWO4 samples were obtained in the shape of nanorods or a mixture of nanorods and granular particles. Moreover, it was demonstrated that F-doped ZnWO4 enhanced photocatalytic activity by a factor of three, as compared to that of un-doped ZnWO4. This enhancement can be explained by the nanowire shape of synthesized F-doped ZnWO4, its narrow band gap energy and the small recombination rate of photogenerated electron-hole pairs, which was indirectly proved by PL spectra.