Superparamagnetic magnetite-alginate nanoparticles (M-AlgNPs) were synthesized utilizing a coprecipitation method. Then, the prepared M-AlgNPs were characterized via Fourier transform infrared spectroscopy (FTIR) and X-ray diffraction spectroscopy (XRD) to affirm the formation and the crystallinity of this composite. In addition, the surface morphology of the prepared nanoparticles was inspected by transmission electron microscopy (TEM) which revealed well-dispersed nanoparticles of Fe3O4 into alginate. The adsorption characteristics of the synthesized nanoparticles for removing Ni+2 and Co+2 from wastewater were evaluated via atomic absorption measurements (AAS). The elimination efficiency of the M-AlgNPs was detected at in 100 ppm (initial concentration) of Ni+2 and Co+2, separately. The M-AlgNPs provided the maximum equilibrium uptake percentage for Ni+2 and Co+2 of 97.88 and 95.01%, respectively. The adsorption of Ni+2 and Co+2 onto the M-AlgNP surface was found to fit the Langmuir model with values higher than that obtained from the Freundlich model for both metal ions. Moreover, “separating factor” for the adsorption process was assessed and found to be less than unity; this expresses the higher ability of the investigated metal ions to be adsorbed onto the M-AlgNP surface. The adsorption method was discovered to be pH-dependent and well-suited to the isothermal equations of Langmuir and Freundlich. For regeneration studies, M-AlgNPs have been investigated and results confirmed that it could be reused with effective sorption capacity over three cycles.
2 February 2019 in International Journal of Environmental Science and Technology
α-aminophosphonate (α-AP) is used as a novel corrosion inhibitor for carbon steel. The aggressive media applied in this study are HCl and H2SO4 acid solutions. The findings indicate that the morphology of the α-AP compound is cubic, with particles ranging in size from 17 to 23 μm. FT-IR, 1HNMR, 31PNMR, and 13CNMR analysis confirmed the synthesis of the α-AP molecule. It has been discovered that the compound α-AP plays an important role in inhibiting the corrosion of carbon steel in both HCl and H2SO4 acids. This was identifiably inferred from the fact that the addition of α-AP compound decreased the corrosion rate. It is important to report that the maximum inhibition efficiency (92.4% for HCl and 95.7% for H2SO4) was obtained at 180 ppm. The primary factor affecting the rate at which steel specimens corrode in acidic electrolytes is the tendency of α-AP compounds to adsorb on the surface of steel through their heteroatoms (O, N, and P). This was verified by SEM/EDX results. The adsorption actually occurs through physical and chemical mechanisms via different active centers which are matched with the calculated quantum parameters. In addition, the adsorption of α-AP follows the Langmuir isotherm.
10 June 2020 in International Journal of Tropical Insect Science
The efficiency of 1,3-benzodioxole derivatives as corrosion inhibitors is theoretically studied using quantum chemical calculation and Quantitative Structure Activity Relationship (QSAR). Different semiempirical methods (AM1, PM3, MNDO, MINDO/3, and INDO) are applied in order to determine the relationship between molecular structure and their corrosion protection efficiencies. Different quantum parameters are obtained as the energy of highest occupied molecular orbital, the energy of the lowest unoccupied molecular orbital, energy gap, dipole momentμ, and Mulliken charge on the atom. QSAR approach is applied to elucidate some important parameters as the hydrophobicity (Log P), surface area (S.A), polarization, and hydration energy ().