This paper proposes an RF-to-dc power converter for ambient wireless powering that is efficient, highly sensitive, and less dependent on the load resistance with an extended dynamic range. The proposed rectifier utilizes a variable biasing technique to control the conduction of the rectifying transistors selectively, hence minimizing the leakage current; unlike the prior work that has a fixed feedback resistors, which limits the efficient operation to a relatively high RF power and causes a drop in the peak power conversion efficiency (PCE). The proposed design is fabricated using a 0.18-μm standard CMOS technology and occupies an area of 8800 μm². The measurement results show an 86% PCE and -19.2-dBm (12 μW) sensitivity when operating at the medical band 433 MHz with a 100-kΩ load. Furthermore, the PCE is 66%, and the sensitivity is -18.2 dBm (15.1 μW) when operating at UHF 900 MHz with a 100-kΩ load.

Recently, the bubble-based systems have offered a new paradigm in microfluidics. Gas bubbles are highly flexible, controllable and barely mix with liquids and thus can be used for the creation of reconfigurable microfluidic systems. In this work, a hydrodynamically actuated bubble-based microfluidic system is introduced. This system enables the precise movement of air bubbles via axillary feeder channels to alter the geometry of the main channel and consequently the flow characteristics of the system. Mixing of neighbouring streams is demonstrated by oscillating the bubble at desired displacements and frequencies. Flow control is achieved by pushing the bubble to partially or fully close the main channel. Patterning of suspended particles is also demonstrated by creating a large bubble along the sidewalls. Rigorous analytical and numerical calculations are presented to describe the operation of the system. The examples presented in this paper highlight the versatility of the developed bubble-based actuator for a variety of applications; thus providing a vision that can be expanded for future highly reconfigurable microfluidics.

Graphene has shown considerable potential for sensing magnetic fields based on the Hall Effect, due to its high carrier mobility, low sheet carrier density, and low-temperature dependence. However, the cost of graphene in comparison to conventional materials has meant that its uptake in electronic manufacturing has been slow. To lower technological barriers and bring more widespread adoption of graphene Hall sensors, we are using a one-step laser scribing process that does not rely on multiple steps, toxic chemicals, and subsequent treatments. Laser-scribed graphene Hall sensors offer a linear response to magnetic fields with a normalized sensitivity of ~1.12 V/AT. They also exhibit a low constant noise voltage floor of ~ 50 nV/ $$\sqrt {{\mathrm{Hz}}}$$Hz for a bias current of 100 µA at room temperature, which is comparable with state-of-the-art low-noise Hall sensors. The sensors combine a high bendability, come with high robustness and operating temperatures up to 400 °C. They enable device ideas in various areas, for instance, soft robotics. As an example, we combined a laser-scribed graphene sensor with a deformable elastomer and flexible magnet to realize low-cost, compliant, and customizable tactile sensors.

This paper presents an improved StrongARM latch comparator, designed and simulated in 90nm and 32nm CMOS technologies. The proposed design provides an improvement of 7% in energy efficiency, 14% in speed and an average reduction of 41% in the clock feedthrough, compared to the conventional design. The new architecture also minimizes the area by reducing the required transistors needed for the enhanced performance.