Typhoon Morakot struck Taiwan during 6–9 August 2009, and it produced the highest rainfall (approaching 3000 mm) and caused the worst damage in the past 50 yr. Typhoon–monsoon flow interactions with mesoscale convection, the water vapor supply by the monsoon flow, and the slow moving speed of the storm are the main reasons for the record-breaking precipitation. Analysis of the typhoon track reveals that the steering flow, although indeed slow, still exceeded the typhoon moving speed by approximately 5 km h−1 (1 km h−1 = 0.28 m s−1) during the postlandfall period on 8 August, when the rainfall was the heaviest. The Cloud-Resolving Storm Simulator (CReSS) is used to study the dynamics of the slow storm motion toward the north-northwest upon leaving Taiwan. The control simulations with 3-km grid size compare favorably with the observations, including the track, slow speed, asymmetric precipitation pattern, mesoscale convection, and rainfall distribution over Taiwan. Sensitivity tests with reduced moisture content reveal that not only did the model rainfall decrease but also the typhoon translation speed increased. Specifically, the simulations consistently show a discernible impact on storm motion by as much as 50%, as the storms with full moisture move slower (~5 km h−1), while those with limited moisture (≤25%) move faster (~10 km h−1). Thus, in addition to a weak steering flow, the prolonged asymmetric precipitation in Typhoon Morakot also contributed to its very slow motion upon leaving Taiwan, and both lengthened the heavy-rainfall period and increased the total rainfall amount. The implications of a realistic representation of cloud microphysics from the standpoint of tropical cyclone track forecasts are also briefly discussed.

In this case study, numerical simulations using the Weather Research and Forecasting model (WRF) are performed for 3–4 May 2002, in which two propagating rain episodes occurred in successive days with close ties to the terrain of the Tibetan Plateau (TP) in East Asia. Through sensitivity tests, it is found that the eastern TP not only facilitated convective development in the afternoon but that the solenoidal circulation between this region and its leeside lowlands (near the Sichuan basin) also contributed to the longevity and farther downstream propagation of the episodes under prevailing westerly winds. Reversed every 12 h, the thermally driven circulation induced ascending motion near the eastern edge of the TP during daytime but over the leeside at night. The episode propagation in this case, as often observed, was in phase with the ascent, from eastern TP in the afternoon to the lee at night, indicating both enhancing and modulating effects of the solenoidal circulation.

Typhoon Fanapi (2010) traveled westward across the Central Mountain Range of Taiwan on 19 September and its rainfall shifted from a symmetric to an asymmetric pattern with convection mostly to the south and southeast. Meanwhile, the storm slowed down from 22 to 14 km h⁻¹ for 12 h upon leaving Taiwan, and led to heavy rainfall (>800 mm) and serious flooding over the low‐lying southwestern plains. Through simulation and sensitivity tests using the Cloud‐Resolving Storm Simulator at 3 km grid size, this study shows that the sudden and temporary speed reduction was caused by the asymmetric latent heating (LH), not the environmental flow. Specifically, over a 9 h period, the model storm moved westward at 16 km h⁻¹ in the control run, but increasingly faster and more toward the northwest when the moisture (and thus the LH effect and its asymmetry) is gradually reduced. Steering flow analysis and estimation using model results suggest an eastward motion vector of about 8 km h⁻¹, consistent with the observation, is produced by the asymmetric LH effect, when the effects from the vertical wind shear and beta‐drift are both taken into account. This result is further supported by the diagnosis on storm motion based on potential vorticity tendency. Although important, such feedback to typhoon track from rainfall asymmetry that is induced by the blocking effect of topography have not been reported or studied.

During 11–12 June 2012, quasistationary linear mesoscale convective systems (MCSs) developed near northern Taiwan and produced extreme rainfall up to 510 mm and severe flooding in Taipei. In the midst of background forcing of low-level convergence, the back-building (BB) process in these MCSs contributed to the extreme rainfall and thus is investigated using a cloud-resolving model in the case study here. Specifically, as the cold pool mechanism is not responsible for the triggering of new BB cells in this subtropical event during the meiyu season, we seek answers to the question why the location about 15–30 km upstream from the old cell is still often more favorable for new cell initiation than other places in the MCS. With a horizontal grid size of 1.5 km, the linear MCS and the BB process in this case are successfully reproduced, and the latter is found to be influenced more by the thermodynamic and less by dynamic effects based on a detailed analysis of convective-scale pressure perturbations. During initiation in a background with convective instability and near-surface convergence, new cells are associated with positive (negative) buoyancy below (above) due to latent heating (adiabatic cooling), which represents a gradual destabilization. At the beginning, the new development is close to the old convection, which provides stronger warming below and additional cooling at mid-levels from evaporation of condensates in the downdraft at the rear flank, thus yielding a more rapid destabilization. This enhanced upward decrease in buoyancy at low levels eventually creates an upward perturbation pressure gradient force to drive further development along with the positive buoyancy itself. After the new cell has gained sufficient strength, the old cell's rear-flank downdraft also acts to separate the new cell to about 20 km upstream. Therefore, the advantages of the location in the BB process can be explained even without the lifting at the leading edge of the cold outflow.

This paper investigates the formation and evolution of deep convection inside the east–west oriented rainbands associated with a low-level jet (LLJ) in Typhoon Morakot (2009). With the typhoon center to the northwest of Taiwan, the westerly LLJ occurred as a result from the interaction of typhoon circulation with the southwest monsoon flow, which supplied the water vapor for the extreme rainfall (of ~ 1000 mm) over southwestern Taiwan. The Cloud-Resolving Storm Simulator with 1 km grid spacing was used to simulate the event, and it successfully reproduced the slow-moving rainbands, the embedded cells, and the dynamics of merger and back-building (BB) on 8 August as observed. Our model results suggest that the intense convection interacted strongly with the westerly LLJ that provided reversed vertical wind shear below and above the jet core. Inside mature cells, significant dynamical pressure perturbations (p'_d) are induced with positive (negative) p'_d at the western (eastern) flank of the updraft near the surface and a reversed pattern aloft (> 2 km). This configuration produced an upward-directed pressure gradient force (PGF) to the rear side and favors new development to the west, which further leads to cell merging as the mature cells slowdown in eastward propagation. The strong updrafts also acted to elevate the jet and enhance the local vertical wind shear at the rear flank. Additional analysis reveals that the upward PGF there is resulted mainly by the shearing effect but also by the extension of upward acceleration at low levels. In the horizontal, the upstream-directed PGF induced by the rear-side positive p'_d near the surface is much smaller, but can provide additional convergence for BB development upstream. Finally, the cold-pool mechanism for BB appears to be not important in the Morakot case, as the conditions for strong evaporation in downdrafts do not exist.

An extreme-rainfall-producing mesoscale convective system (MCS) associated with the Changma front in southeastern South Korea was investigated using observational data. This event recorded historic rainfall and led to devastating flash floods and landslides in the Busan metropolitan area on 7 July 2009. The aim of the present study is to analyse the influences for the synoptic and mesoscale environment, and the reasons that the quasi-stationary MCS causes extreme rainfall. Synoptic and mesoscale analyses indicate that the MCS and heavy rainfall occurred in association with a stationary front which resembled a warm front in structure. A strong southwesterly low-level jet (LLJ) transported warm and humid air and supplied the moisture toward the front, and the air rose upwards above the frontal surface. As the moist air was conditionally unstable, repeated upstream initiation of deep convection by back-building occurred at the coastline, while old cells moved downstream parallel to the convective line with training effect. Because the motion of convective cells nearly opposed the backward propagation, the system as a whole moved slowly. The back-building behaviour was linked to the convectively generated cold pool and its outflow boundary, which played a role in the propagation and maintenance of the rainfall system. As a result, the quasi-stationary MCS caused a prolonged duration of heavy rainfall, leading to extreme rainfall over the Busan metropolitan area.