A novel few-layer MoS2/SiO2/Si heterojunction is fabricated via DC magnetron sputtering technique, and Pd nanoparticles are further synthesized on the device surface. The results demonstrate that the fabricated sensor exhibits highly enhanced responses to H2 at room temperature due to the decoration of Pd nanoparticles. For example, the Pd-decorated MoS2/SiO2/Si heterojunction shows an excellent response of 9.2 × 103% to H2, which is much higher than the values for the Pd/SiO2/Si and MoS2/SiO2/Si heterojunctions. In addition, the H2 sensing properties of the fabricated heterojunction are dependent largely on the thickness of the Pd-nanoparticle layer and there is an optimized Pd thickness for the device to achieve the best sensing characteristics. Based on the microstructure characterization and electrical measurements, the sensing mechanisms of the Pd-decorated MoS2/SiO2/Si heterojunction are proposed. These results indicate that the Pd decoration of few-layer MoS2/SiO2/Si heterojunctions presents an effective strategy for the scalable fabrication of high-performance H2 sensors.
Two groups of heteroleptic Cu(I)-based dyes were designed and theoretically investigated by density functional theory (DFT) and time-dependent DFT (TD-DFT) methods. Different anchors were integrated into the dye skeleton to shed light on how the type of anchor influenced the electronic structure, absorption spectrum, electron excitation, and intramolecular and interfacial electron transfer of dyes. The results indicated that, compared with other dyes, the dyes with cyanoacrylic acid and nitric acid exhibited more appropriate electron distributions in frontier molecular orbitals (FMOs), lower HOMO (the highest occupied molecular orbital) –LUMO (the lowest unoccupied molecular orbital) energy gaps, broader absorption spectral ranges as well as improved spectral characteristics in the near-infrared region and better intramolecular electron transfer (IET) characteristics with more electrons transferred to longer distances, but smaller orbital overlap. Among all the studied Cu(I)-based dyes, B1 and P1 (with cyanoacrylic acid anchoring group) exhibited the best interface electronic structure parameters with a relatively short electron injection time (τinj) and large dipole moment (μnormal), which would have a positive effect on the open-circuit photovoltage (Voc) and short-circuit current density (Jsc), resulting in high power conversion efficiency (PCE) of dye-sensitized solar cells (DSSCs). Our findings are expected to provide a new insight into the designing and screening of high-performance dyes for DSSCs.
Molybdenum disulfide (MoS2) nanoscaled films are deposited on GaAs substrates via magnetron sputtering technique, and MoS2/GaAs heterojunctions are fabricated. The lateral photovoltaic effect (LPE) of the fabricated MoS2/GaAs heterojunctions is investigated. The results show that a large LPE can be obtained in the MoS2/n-GaAs heterojunction. The LPE exhibits a linear dependence on the position of the laser illumination and the considerably high sensitivity of 416.4 mV mm− 1. This sensitivity is much larger than the values in other reported MoS2-based devices. Comparatively, the LPE in the MoS2/p-GaAs heterojunction is much weaker. The mechanisms to the LPE are unveiled by constructing the energy-band alignment of the MoS2/GaAs heterojunctions. The excellent LPE characteristics make MoS2 films combined with GaAs semiconductors promising candidates for the application of high-performance position-sensitive detectors.
1 September 2014 in Journal of Molecular Structure