Haze in China has been increasing in frequency of occurrence as well as the area of the affected region. Here, we report on a new mechanism of haze formation, in which coexistence with NOx can reduce the environmental capacity for SO2, leading to rapid conversion of SO2 to sulfate because NO2 and SO2 have a synergistic effect when they react on the surface of mineral dust. Monitoring data from five severe haze episodes in January of 2013 in the Beijing-Tianjin-Hebei regions agreed very well with the laboratory simulation. The combined air pollution of motor vehicle exhaust and coal-fired flue gases greatly reduced the atmospheric environmental capacity for SO2, and the formation of sulfate was found to be a main reason for the growth of fine particles, which led to the occurrence of haze. These results indicate that the impact of motor vehicle exhaust on the atmospheric environment might be underestimated.
23 July 2020 in Environmental Science & Technology Letters
Hygroscopicity is one of the most important physicochemical properties of aerosol particles and also plays indispensable roles in many other scientific and technical fields. A myriad of experimental techniques, which differ in principles, configurations and cost, are available for investigating aerosol hygroscopicity under subsaturated conditions (i.e., relative humidity below 100 %). A comprehensive review of these techniques is provided in this paper, in which experimental techniques are broadly classified into four categories, according to the way samples under investigation are prepared. For each technique, we describe its operation principle and typical configuration, use representative examples reported in previous work to illustrate how this technique can help better understand aerosol hygroscopicity, and discuss its advantages and disadvantages. In addition, future directions are outlined and discussed for further technical improvement and instrumental development.
12 October 2011 in Physical Chemistry Chemical Physics
Sulfate is one of the most important aerosols in the atmosphere. A new sulfate formation pathway via synergistic reactions between SO2 and NO2 on mineral oxides was proposed. The heterogeneous reactions of SO2 and NO2 on CaO, α-Fe2O3 , ZnO, MgO, α-Al2O3 , TiO2 , and SiO2 were investigated by in situ Diffuse Reflectance Infrared Fourier Transform Spectroscopy (in situ DRIFTS) at ambient temperature. Formation of sulfate from adsorbed SO2 was promoted by the coexisting NO2 , while surface N2O4 was observed as the crucial oxidant for the oxidation of surface sulfite. This process was significantly promoted by the presence of O2. The synergistic effect between SO2 and NO2 was not observed on other mineral particles (such as CaCO3 and CaSO4 ) probably due to the lack of the surface reactive oxygen sites. The synergistic reaction between SO2 and NO2 on mineral oxides resulted in the formation of internal mixtures of sulfate, nitrate, and mineral oxides. The change of mixture state will affect the physicochemical properties of atmospheric particles and therefore further influence their environmental and climate effects.
Intense and frequent new particle formation (NPF) events have been observed in polluted urban environments, yet the dominant mechanisms are still under debate. To understand the key species and governing processes of NPF in polluted urban environments, we conducted comprehensive measurements in downtown Beijing during January–March, 2018. We performed detailed analyses on sulfuric acid cluster composition and budget, as well as the chemical and physical properties of oxidized organic molecules (OOMs). Our results demonstrate that the fast clustering of sulfuric acid (H2SO4) and base molecules triggered the NPF events, and OOMs further helped grow the newly formed particles toward climate‐ and health‐relevant sizes. This synergistic role of H2SO4, base species, and OOMs in NPF is likely representative of polluted urban environments where abundant H2SO4 and base species usually co‐exist, and OOMs are with moderately low volatility when produced under high NOx concentrations.