The discrete element method (DEM) has been widely employed to model processes in different industries, such as mining, agriculture, pharmaceuticals, and food. One of the main lines of research, and in which different authors propose several approaches, is the calibration of parameters. Bulk calibration (BCA) is a common approach used that does not necessarily represent the individual behavior of each particle. On the other hand, direct measurement (DMA) is another approach employed in some cases. This work presents a comparison between calibration of DEM model parameters with non-cohesive spherical and polyhedral particles using a combination of direct measurement and bulk calibration. BCA is employed to calibrate friction parameters and DMA to characterize shape of the particles and coefficient of restitution of the contact between particles. Experimental data from Draw Down Tests are used to calibrate the friction parameters. Numerical optimization of the parameters is conducted by altering the coefficients of friction regarding the objective variables of mass flow, final mass, shear angle, and angle of repose. Quartz, granite, and coal are calibrated, obtaining good agreement with the experimental results. The influence of particle shape is tested, proving that more complex particles obtain better results for the analyzed case.

Comminution by gyratory crusher is the first stage in the size reduction operation in mineral processing. In the copper industry, these machines are widely utilized, and their reliability has become a relevant aspect. To optimize the design and to improve the availability of gyratory crushers, it is necessary to calculate their power and torque accurately. The discrete element method (DEM) has been commonly used in several mining applications and is a powerful tool to predict the necessary power required in the operation of mining machines. In this paper, a DEM model was applied to a copper mining gyratory crusher to perform a comprehensive analysis of the loads in the mantle, the crushing torque, and crushing power. A novel polar representation of the radial forces is proposed that may help designers, engineers, and operators to recognize the distribution of force loads on the mantle in an easier and intuitive way. Simulations with different operational conditions are presented and validated through a comparison with nominal data. A calculation procedure for the crushing power of crushers is presented, and recommendations for the selection of the minimum resolved particle size are given.

Shear-induced polymer-bridging flocculation is widely used in the solid–liquid separation process in cemented paste backfill, beneficial to water recycling and tailings management in metal mines. A flocculation kinetics model based on Population Balance Model (PBM) is proposed to model the polymer-bridging flocculation process of total tailings. The PBM leads to a system of ordinary differential equations describing the evolution of the size distribution, and incorporates an aggregation kernel and a breakage kernel. In the aggregation kernel, a collision frequency model describes the particle collision under the combined effects of Brownian motions, shear flow, and differential sedimentation. A semi-empirical collision efficiency model with three fitting parameters is applied. In the breakage kernel, a new breakage rate coefficient model with another three fitting parameters is introduced. Values of the six fitting parameters are determined by minimizing the difference between experimental data obtained from FBRM and modeling result through particle swarm global optimization. All of the six fitting parameters vary with flocculation conditions. The six fitting parameters are regressed with the flocculation factors with six regression models obtained. The validation modeling demonstrates that the proposed PBM quantifies well the dynamic evolution of the floc size during flocculation under the given experimental setup. The investigation will provide significant new insights into the flocculation kinetics of total tailings and lay a foundation for studying the performance of the feedwell of a gravity thickener.