This paper presents a performance evaluation of the development of the instrumentation, communications and control systems of a two-tank process by using low-cost hardware and open source software. The hardware used for automating this process consists of embedded platforms (Arduino and Raspberry Pi) integrated into programmable logic controllers (PLCs), which are connected to a supervisory control and data acquisition (SCADA) system implemented with an open source Industrial Internet of Things (IIoT) platform. The main purpose of the proposed approach is to evaluate low-cost automation solutions (hardware and software) within the framework of modern industry requirements in order to determine whether these technologies could be enabling factors of IIoT. The proposed control strategy for regulating tank levels combines the classic PID algorithm and the fuzzy gain scheduling PID (FGS-PID) approach. Fault detection capabilities are also enabled for the system through a fault detection and diagnosis module (FDD) implemented with an extended Kalman filter (EKF). The distributed controller’s (DC) algorithms are embedded into the PLC’s processors in order to demonstrate the flexibility of the proposed system. Additionally, a remote human to machine interface (HMI) is deployed through a web client of the IIoT application. Experimental results show the proper operation of the overall system.
We have investigated the magnetic depth profile of an epitaxial Fe3O4 thin film grown directly on a semiconducting ZnO substrate by soft x-ray resonant magnetic reflectometry (XRMR) and electron energy loss spectroscopy (EELS). Consistent chemical profiles at the interface between ZnO and Fe3O4 are found from both methods. Valence selective EELS and XRMR reveal independently that the first monolayer of Fe at the interface between ZnO and Fe3O4 contains only Fe3+ ions. Besides this narrow 2.5 Å interface layer, Fe3O4 shows magnetic bulk properties throughout the whole film making highly efficient spin injection in this system feasible.
El presente artículo muestra el análisis, la metodología y los resultados obtenidos del grupo de estudiantes del tercer año de Bachillerato General Unificado de la Unidad Educativa Particular “La Providencia” de la ciudad de Azogues al haber cumplido como objetivo: mejorar los aprendizajes de los alumnos en el Dominio Matemático a través del uso de Geogebra, para cumplir con este objetivo se ha tomado como metodología partir de una evaluación en línea que simula el examen Ser Bachiller, luego observar los resultados referentes al Dominio Matemático y marcar los contenidos temáticos en las que menos puntuaron, y así proponer mecanismos de aprendizaje con la ayuda de Geogebra, y finalmente después de llevar el proceso de aprendizaje se procede a realizar una nueva simulación para evidenciar los nuevos resultados, compararlos y obtener conclusiones.
In the present project shows the design and implementation of an e-call system by programming a GPS / GPRS module, the purpose is to obtain the geographical coordinates of positioning of a vehicle that will be sent immediately to the activation of an impact sensor, an operator receives and feeds the information to a web page, to finally be shown in a spreadsheet through CDXZipStream, allowing to perform route calculations, in addition, compare distance in (km) and time in (minutes) of those of the different routes. The system also makes an automatic call to communicate the crew of the vehicle with an operator, so that they can interact in this way. The results show a reduction in the response time by the emergency services in the event of a collision between one or more vehicles